How much fluid does a 4L60E transmission hold?
The fluid capacity of the 4L60e is 12 quarts of transmission fluid (dry). This amount is based on a stock, “shallow” transmission pan with a 12″ torque converter.
How much fluid does a 4L60E take after rebuild?
A 4L60E will take 4-6 quarts on a fluid and filter change.
Can you swap a 4L60E for a 4L80E?
Upgrading from the 4L60E to the 4L80E is akin to going from a Dana 44 axle to a Dana 60–you’ll add some weight, but also add durability. According to GM Powertrain information, the 4L60E has a maximum engine torque rating of 360 lb-ft and a maximum gearbox torque rating of 610 lb-ft.
How do you drain the transmission fluid on a 4l60e?
Removal Procedure
- Locate the upper transmission line on the passenger side and remove the line from your vehicle’s radiator.
- Once the line is removed, connect your brass trans cooler line fitting.
- Route the tubing to your catch pan or bucket.
- Now you will begin to flush the fluid.
How many quarts of fluid does a transmission take?
In general, transmissions take about 9 to 13 quarts to fill completely. The amount of transmission you add will vary, depending on whether you are draining or replacing it all or you are just topping it up. Again, you should avoid adding too much. It is advisable to put in little amounts at a time.
How many quarts of fluid to fill 4L60E at service?
The 4L60e’s fluid volume is 12 quarts (dry) of transmission fluid. This volume is based on a stock, with a 12 “torque converter,” shallow “transmission pan.” The ability of additional fluid will range from an extra quart or more with a deep pan.
How much fluid does the transmission take?
Most passenger vehicles take from 12 to 16 quarts of transmission fluid, but the model of the vehicle dictates the type and how much. While many vehicles come with a dipstick to check the transmission fluid, there are other models that do not.
What is the length of a 4L60E?
The 4L60E has a weight of 150 lbs without fluid and the length of 23.5″, while the 4L80e have the weight of 236 lbs and the length of 26.4″. Just with these number, you can probably calculate that there is a big difference in size and weight between these transmissions.