How much does it cost to rebuild an AW4 transmission?
$1800-2100 for a rebuild.
What do you need to rebuild a jeep AW4?
Platinum Lubegard – Insider tip: Many shops use this synthetic supplement in every freshly rebuilt transmission to keep them on the road past the warranty. The Transtec soft parts kit includes all of the rubber seal and gaskets that you will need to complete your rebuild. These transmissions were used in Jeep applications from 1987-2001.
When did the Jeep AW4 transmission come out?
These transmissions were used in Jeep applications from 1987-2001. This transmission can be identified by the 19 bolt, rectangular shaped oil pan and 4 forward gears. These transmissions can be found in the following vehicles; however you should double check your application with the bolt count.
Is the AW4 transmission a replacement for Isuzu?
We have carefully engineered a process that allows a AW4 rebuild to maximize performance and durability while staying within a wholesale price range. This heavy duty transmission is a direct replacement for Isuzu, and Jeep vehicles.
What’s the difference between a 1990 AW4 and 1996 AW4?
This is due to the difference in throttle bodies and linkages. 1990.5-1996, the AW4 switched to a 23 spline output shaft and a 0.75:1 OD ratio. It was no longer available behind the 2.5L engine. Otherwise, it remained exactly the same.
Platinum Lubegard – Insider tip: Many shops use this synthetic supplement in every freshly rebuilt transmission to keep them on the road past the warranty. The Transtec soft parts kit includes all of the rubber seal and gaskets that you will need to complete your rebuild. These transmissions were used in Jeep applications from 1987-2001.
These transmissions were used in Jeep applications from 1987-2001. This transmission can be identified by the 19 bolt, rectangular shaped oil pan and 4 forward gears. These transmissions can be found in the following vehicles; however you should double check your application with the bolt count.
Can a jeep AW4 be used in a jeep Dana 300?
The Jeep AW4 was factory-married to the Jeep Jeep New Process (aka New Venture) Model 231 transfer case, in addition to the NP242 Full-Time transfer case. It is possible to adapt the AW4 to the Jeep Dana 300 transfer case in passenger side and driver side drop by using Novak kit #153 in the event one is installing a 4.0L into an ’80s era CJ.
What is the output shaft on a jeep AW4?
The earlier Jeep AW4 has a 21 spline output shaft for connecting to the transfer case input shaft. With the release of the HO 4.0L in the 1991 the AW4 was upgraded to a 23 spline output shaft.