How much does it cost to diagnose p0402 Ford code?
Labor: 1.0 The cost of diagnosing the P0402 FORD code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. When is the P0402 FORD code detected? High Exhaust Gas Recirculation (EGR) flow control is detected
What causes the p0402 code on an EGR?
Code P0402 is triggered when the EGR temperature sensor sees more of a temperature change than the EGR has commanded to open. This is usually caused by the EGR backpressure control valve getting a burnt diaphragm from the exhaust backpressure over time or from a partly blocked catalyst. Need help with a P0402 code?
What was the cause of the p0402 gas leak?
P0402 – Exhaust gas recirculation (EGR) system -excessive flow detected Trouble Code Fault Location Probable Cause P0402 Exhaust gas recirculation (EGR) system – Hose leak/blockage, basic setting not ca
What is the diagnostic code for excessive EGR flow?
There is another diagnostics connector in the engine compartment that will not fit the OBDC-II scanner tool, and you may have to point the technician to the proper connector (like I did) if you take it to a place like AutoZone. If the code is P0402, the diagnosis is excessive EGR (exhaust gas recalculation) flow.
Code P0402 is triggered when the EGR temperature sensor sees more of a temperature change than the EGR has commanded to open. This is usually caused by the EGR backpressure control valve getting a burnt diaphragm from the exhaust backpressure over time or from a partly blocked catalyst. Need help with a P0402 code?
Labor: 1.0 The cost of diagnosing the P0402 FORD code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. When is the P0402 FORD code detected? High Exhaust Gas Recirculation (EGR) flow control is detected
What causes an OBD code of p0403?
The causes for a P0403 EGR code could be any of the following: Bad EGR solenoid Excessive resistance in control circuit (PCM controlled ground) due to an open, chafing or damage to the harness Poor connection at the EGR solenoid harness (worn or loose pins) Water intrusion at the EGR solenoid harness