How much does it cost to diagnose a p1221 code?
The cost of diagnosing the P1221 code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. The Throttle Position (TP) Sensor is mounted on the throttle body of the Throttle Actuator Control (TAC) assembly.
What are the trouble codes on a Mitsubishi?
Diagnostic trouble codes may be cleared by disconnecting the battery ground cable for at least 20 seconds. Reconnect negative battery cable and recheck codes to confirm the repair. Oxygen sensor fault. Airflow sensor fault. Intake air temp sensor fault. Throttle position sensor (TPS) fault. Idle speed control (ISC) motor position sensor fault.
What are the diagnostic codes for the Mitsubishi OBD I?
Barometric (BARO) pressure sensor fault 95-98 Eclipse Non Turbo) Idle Air Control (IAC) Motor Circuits; Target Idle Not Reached (plus or minus 200 RPM) 27 95-98 Eclipse Non Turbo) Injector Control Circuit 1,2,3 or 4 31 V6 and 89-95 4 Cyl.
The cost of diagnosing the P1221 code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour. The Throttle Position (TP) Sensor is mounted on the throttle body of the Throttle Actuator Control (TAC) assembly.
What is the diagnostic code for a Mitsubishi check engine?
Refer to our Generic OBD II code list for definitions on all other Mitsubishi diagnostic trouble codes. Manufacturer Specific Codes P1100Induction Control Motor Position Sensor Fault P1101Traction Control Vacuum Solenoid Circuit Fault – Read Our Article On Automotive Circuit TestingFor Help With This Mitsubishi Check Engine Light Code
How do you read OBD codes on a Mitsubishi 96?
96 & later are OBD2 systems and require a scanner. Locate Data Link Connector (DLC), next to fuse box. Connect voltmeter positive lead to DLC terminal #1 and Negative lead to terminal #12 (ground). Turn Ignition switch to ON position. codes are read out by 12 volt pulses of voltmeter.
What is throttle position sensor on Mitsubishi OBD I?
No Change In Manifold Absolute Pressure (MAP) From Start To Run 14 V6 and 89-95 4 Cyl. (Exc. 95 Eclipse) Throttle position sensor (TPS) fault
What does the p2101 code on the throttle plate mean?
From there, your vehicle’s throttle plate will open and close according to the signal sent by your vehicle’s PCM. The P2101 code will trigger once the PCM detects that the electronic throttle actuator is not following commands. For example, when the throttle is not opening accordingly.
When to use the p2101 code on a Honda Accord?
The P2101 code will trigger once the PCM detects that the electronic throttle actuator is not following commands. For example, when the throttle is not opening accordingly. Many owners have reported P2101 for the following makes: Honda (especially on a Honda Accord), Chevrolet, Nissan, GMC, and Chrysler.
Where is the TP sensor on a TAC?
The Throttle Position (TP) Sensor is mounted on the throttle body of the Throttle Actuator Control (TAC) assembly. The sensor is actually 2 individual throttle position sensors within 1 housing.