How many Harley Cam tensioners are left in stock?
Only 8 left in stock – order soon. . Only 11 left in stock (more on the way). . Only 4 left in stock – order soon. . Only 9 left in stock – order soon. . . Only 7 left in stock – order soon. . Only 2 left in stock – order soon.
What are the parts in a cam conversion kit?
(A) Oil Pump Assembly, (B) Cam Support Plate, (C) Camshafts, (D) Outer Roller Chain, (E) Retaining Ring (front cam), (F) Outer Chain Tensioner, (G) Crankshaft Sprocket, (H) Rear Cam Sprocket, (I) Spacer, (J) Inner Roller Chain, (K) Inner Chain Tensioner. On the top is the old-style Hyvo chain and camshaft.
How big is the roller chain on an Andrew Cam?
Both ends of the cam are the same diameter. On the bottom is the new roller chain along with one Andrews conversion cam. On the case side of the cam (left in this photo), the diameter is 0.875 inches to fit into the existing cam bearing in the case, while the outer diameter of the cam that spins in the cam support plate is larger.
What kind of bearings are in Harley Davidson cams?
Cam chains were kept taut with spring-loaded cam chain tensioners made from Dupont Vespel. Both camshafts rested in 0.875-inch-diameter bearings that were pressed into the case, while the other end of the cams spun in bearings attached to the cam support plate.
What kind of tensioner does a cam chest bike use?
The more run out the less consistency on the you cam chain tensioners tension (more pad wear) 06- Current – These bikes have the best all around stock tensioners, hydraulic oil fed with delrin style pads.
What was the problem with the Twin Cams?
The problem that haunted most of these early twin cam models was the fact that the chains were made with sharp ridges on the outer plates that quickly ate away at the plastic tensioner. being spring loaded, there was always constant pressure on that chain, unlike newer models where the tensioners fill with oil.
Which is the best stock tensioner for a bike?
06- Current – These bikes have the best all around stock tensioners, hydraulic oil fed with delrin style pads. These were the best mix because they are able top place more or relieve tensioner tension with each rotation because of the lighter preload put on the chain.
What kind of cam plate do you use on a Dyna?
On your early models you can take a plate and pump combo from a 06 up dyna and use either Andrews or Feuling conversion cams which will allow the newer plate and eliminate the spring loaded tensioners while allowing you to also update the cam plate to the non bearing bushing style outer cam roller.