How many digits are in the Harley key fob?
The TSSM code consists of five digits. Each digit can be any number from 1 to 9. The personal code must be used to disarm the security system in case the Harley key FOB becomes unavailable. Harley uses the same five digit pin for all TSSM equipped motorcycles.
What does a red key light on a Harley Davidson mean?
If the security light (the key) stays on solid (not flashing) and the bike starts and runs, it means the bike has thrown a DTC. (diagnostic trouble code) It is essentially the equivalent of the “check engine” light on a car. The procedure for checking the code is posted in the electrical section.
How to change the FOB on a Harley Davidson?
7 Press right turn switch 1 time. left turn switch 3 times. 9 Press right turn switch 1 time. 10 Enter fourth digit of code (1) by pressing left turn switch 1 time. 11 Press right turn switch 1 time. 12 Enter fifth digit of code (3) by pressing left turn switch 3 times.
How to change the factory code on a Harley Davidson?
If you never set your own personal pin code; the default factory code should work. If the code was ever changed, it will not and you will have to bring m/c to the dealership. 1 Set Engine Stop Switch to OFF. 2 Turn Ignition Switch to IGNITION. 3 Hold both turn signals until confirmation. – – ” is displayed in the odometer.
If the security light (the key) stays on solid (not flashing) and the bike starts and runs, it means the bike has thrown a DTC. (diagnostic trouble code) It is essentially the equivalent of the “check engine” light on a car. The procedure for checking the code is posted in the electrical section.
When do the warning lights come on on a Harley Davidson?
Unfortunately, you can drive your brand new Harley off the lot and not get five miles down the road before a warning light comes on. Or, you could be a thousand miles from home when they start flashing. What do they mean?
What does the Check Engine light mean on a Harley Davidson?
Check Engine Light. When the check engine light comes on, it indicates that something is happening or, in some cases, not happening. The easiest way to handle this is to do a “code check.”. The code will indicate what problem you’re facing.