How long should engine fan stay on?

How long should engine fan stay on?

Your car fan will run for a few minutes after you turn off the car then turn off. This is normal in many vehicles, such as BMW or Mercedes-Benz. The radiator fan may run up to five minutes and sometimes longer. Unless there is an electrical issue, it may stay on all the time until it drains the battery.

Should my car fan run all the time?

It can be normal for the cooling fans to run constantly under certain conditions. If the car is hot enough, they may be barely keeping up with demand and stay on. Also, most cars will run the fans at a high speed if the A/C is turned on.

Why are my cooling fans running at all times?

3. Cooling fans stay on at all times. If the cooling fans are staying on at all times, this is another (less common) symptom of a possible problem with the cooling fan relay. If the relay shorts internally, it may cause power to be permanently switched on, which will cause the fans to run at all times.

Why does my truck engine fan keep running?

There is no charge for this service, but standard message and data rates may apply. If the fan is running, it’s for a reason most likely. I wouldn’t want to force it to be off, bad things could happen. Do you often run A/C or defrost mode? That cycles my fan on and off at low speeds frequently. j76ny Thanks this.

Why does my radiator fan run full speed when I start the car?

Immediately upon starting the car, the radiator fan begins to run full speed, even though the car is stone cold. The AC is OFF. The radiator and condenser are BRAND NEW. This problem existed before and after the radiator was replaced. The fan continues to run at its maxiumum speed, regardless of the engine temperature.

What should I do if my fan is running at a constant high speed?

Confirm that there are no leaks at the sensor, that the air-conditioning is operating as expected and that the fan no longer runs at a constant high speed. Finally use the AssistPlus to run a Quick Test and ensure there are no new fault codes.