How long is a drive cycle Jeep?

Jeep Cherokee Drive Cycle Typically driving 200-300 miles over the course of a week and in both city and highway traffic is enough to complete the monitors. Sometimes however the driving pattern required is not met by regular driving, and the specific segments of the entire Drive Cycle must be performed individually.

How to reset your Jeep Wrangler drive cycle?

Jeep Wrangler, Cherokee DRIVE cycles. How to reset your readiness monitors to pass emissions. – YouTube Jeep Wrangler, Cherokee DRIVE cycles. How to reset your readiness monitors to pass emissions. If playback doesn’t begin shortly, try restarting your device.

How long does a Chrysler Drive Cycle take?

Chrysler & Dodge: Drive Cycle Procedures to complete OBD Readiness Monitors. Pre-Conditioning Requirements: 2) Drive (with steady throttle) at a speed between 40 and 60 mph for 8 minutes. 3) Stop and idle for 3 minutes.

What’s the drive cycle procedure for a Dodge?

Driving Procedure 1) Warm engine up for five minutes (must reach closed loop) 2) Drive (with steady throttle) at a speed between 40 and 60 mph for 8 minutes. 3) Stop and idle for 3 minutes.

How to do a drive cycle for OBD?

Chrysler & Dodge: Drive Cycle Procedures to complete OBD Readiness Monitors 1 Cold soak vehicle, start and idle vehicle for 4 minutes. 2 Drive in-town (stop and go) for 5 minutes, using smooth accelerations and decelerations. 3 Stop and idle vehicle for 4 minutes.

How long does a drive cycle take in a Chrysler?

For all drive cycles, make sure the check engine light (MIL) is off. Smoothly acceerate and maintain a speed between 40 to 60 mph for 8 minutes. Stop and idle for 3 minutes. Smoothly accelerate and maintain a speed above 20 mph for 2 minutes.

Navigation