How long does it take to get a p0341 Volkswagen engine code?
Sometimes and in some models, low battery voltage or a weak starter can trigger a Camshaft Position Sensor code. The cost to diagnose the P0341 VOLKSWAGEN code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
How does a mechanic diagnose the p0341 trouble code?
The Check Engine Light will be illuminated and the code is set in ECM memory. The engine could stall or not start when failure is present. The engine may have a misfire and may buck or jerk while driving for an intermittent connection. The engine may not start or have low power if it does start. How does a mechanic diagnose the P0341 code?
When does the cam code 341 come back?
The egr and maf codes are gone, but the cam code 341 still comes back after about 5-8 miles when the car stumbles and gags, it then recovers for a sho… My Camry dies after 20 minutes of driving and then has to sit for a half hour or so before it can start up again.
Why does my engine have a trouble code?
NOTE: In some cases this engine code is generated on vehicles that do not actually have a camshaft position sensor. In those cases it basically means the engine is misfiring badly due to faulty spark plugs, spark plug wires, and often coils. Often relacing the sensor fixes this code, but not necessarily.
What does the p0341 OBD-II trouble code mean?
What the P0341 code means P0341 is an OBD-II generic code that says the engine control module (ECM) detected the engine camshaft position sensor circuit is not within specifications. The sensor pulses do not correlate to the pulses of the crankshaft sensor. What causes the P0341 code?
When do I get a camshaft sensor code p0341?
Code P0341 is triggered when the camshaft sensor does not correlate to the position of the crankshaft. The crankshaft sensor should also be checked during the diagnostic checks for any problems that could cause the code to be received.
How to check your camshaft position sensor code?
Often relacing the sensor fixes this code, but not necessarily. Therefore it’s important to check the following: Check that the wiring isn’t routed too close to any secondary ignition components (coil, spark plug wires, etc.) Visually inspect the wiring at the sensor for any burn marks, discoloration indicative of melting or chafing