How does the SRS reset work on a Honda Accord?
In the case of the SRS reset, you are using a jumper to communicate the reset sequence to the module. I bought the official “tool” from Honda for this task and all it is is a connector with a wire connecting the two terminals. The reset method has you connecting and reconnecting the circuit which can be difficult.
How to reset Honda airbag module after accident?
Honda Airbag SRS Module Crash Reset After Accident. – YouTube Honda Airbag SRS Module Crash Reset After Accident. If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
Which is Honda Accord air bag control module?
We offer a full selection of genuine Honda Accord Air Bag Control Modules, engineered specifically to restore factory performance. Please narrow the SRS Airbag Module results by selecting the vehicle.
Is there a way to reset the SRS light?
O.K., here is the DIY for resetting the memory for your SRS Light. Your SRS Light may trigger and remain illuminated for several reasons. Some of these are: These instructions are intended ONLY for resetting your SRS Indicator Light when it is triggered for the reasons listed above.
In the case of the SRS reset, you are using a jumper to communicate the reset sequence to the module. I bought the official “tool” from Honda for this task and all it is is a connector with a wire connecting the two terminals. The reset method has you connecting and reconnecting the circuit which can be difficult.
How do you turn off the SRS light?
The SRS light should go off. When the light goes off, pull the wires apart. The SRS light should blink twice. Turn off the ignition to start your car as normal. The SRS light should come on, and after a few seconds it will turn off and stay off. Figure 1. Connect a pair of stripped wires to short the MES. Figure 2.
What does the SRS light on airbags mean?
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit.
Why does the SRS light stay on after an accident?
If the car has been in an accident and the air bags went off will the srs light stay on simply because they didn’t reset the system or would it most likely be that the scum dealer I bought this pos from didnt even replace the air bags or anything from the accident…
Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off. When the SRS Light goes off, unshort the wires. The SRS Light will come back on. Short and hold the wires again. The SRS Light will go off. When the SRS Light goes off, unshort the wires. The SRS Light will blink twice.
The SRS light is a warning light for your supplemental restraint system (airbags). An SRS light means that there is a problem in the system. The first thing I would check is the fuse for the SRS unit.
If the car has been in an accident and the air bags went off will the srs light stay on simply because they didn’t reset the system or would it most likely be that the scum dealer I bought this pos from didnt even replace the air bags or anything from the accident…
Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off. When the SRS Light goes off, unshort the wires. The SRS Light will come back on. Short and hold the wires again. The SRS Light will go off. When the SRS Light goes off, unshort the wires. The SRS Light will blink twice.
Where is the MES plug on a Honda Accord?
1. Locate MES Plug. It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. 2. Unplug the MES Plug. It should look like this. 3. Insert one end of speaker wire into MES Plug (one wire in each contact) 4.
Can You unplug the SRS airbag control module?
You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
Where is the SRS computer module in a car?
Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed. First find the srs computer module. In most cars it is under the center console that is between the two front seats, or center of the dash on the floor.
What does EEPROM do to the SRS airbag module?
EEPROM re-programming consists of erasing crash data and hard codes found in the SRS airbag module by rewriting the original factory code into the memory. Your SRS unit will be reprogrammed to the original factory programming and function like new.