How does a Springer style front end work?
Start the stem into the neck, then begin lowering the the motorcycle down over the springer fork. Once the neck stem is fully inserted, the top bearing and dust shield can be installed, followed by the tensioning/adjusting nut. The Springer style front end is one of the earliest motorcycle front end designs. Other early designs were:
What kind of front end does a Harley Davidson have?
The Springer style front end is one of the earliest motorcycle front end designs. Other early designs were: The Girder Fork, Hub Centre Steering (Ner-A-Car), Trailing Link Fork and, of course, The Telescopic Fork. Here is the history of the Harley davidson Springer Front End:
What kind of front end does a Paughco Springer have?
Paughco utilizes Harley Davidson original manufacturer hardware for the majority of their springer front ends. This works out great for an owner. Especially, when it comes to maintenance or repair. Like any Harley Davidson Springer that is 93 & newer, this Paughco springer front end has a floating front fender.
How do you install a springer fork on a motorcycle?
Mating these components is easiest when the front of the frame is lifted on a flat jack. Start the stem into the neck, then begin lowering the the motorcycle down over the springer fork. Once the neck stem is fully inserted, the top bearing and dust shield can be installed, followed by the tensioning/adjusting nut.
Can you change the front end of a Harley Davidson?
Harley-Davidson has designed and manufactured this custom front end according to our very stringent and well-tested standards. If you modify the FLSTS Springer front end in any way that changes our original design, Harley-Davidson cannot and does not assume responsibility for mishaps resulting from these changes. 1WARNING
Can a springer front end be used on a Softail?
Installation of the FLSTS Springer front end on anything other than Softail models could lead to possible personal injury. Do not install on three-wheeled vehicles of any kind. This kit is designed for use with the supplied 16 in. front wheel. Do not use any other front wheel with this kit.
How to install a flsts springer front end?
USE THE APPROPRIATE SERVICE MANUAL PROCEDURES. If the procedure is not within your capabilities or if you do not have the correct tools, have your Harley-Davidson Dealer perform the installation. 1WARNING The components of your FLSTS Springer front end and their design relationship to each other are very important.
Where can I get a Heritage Springer front end kit?
-J00588 REV. 11-19-96 HERITAGE SPRINGER FRONT END KIT GENERAL This kit is designed for installation on 1996 and later Softail motorcycles. See Service Parts illustrations for kit contents. NOTE We recommend this kit be installed by a factory trained tech- nician at an authorized Harley-Davidson Dealership. NOTE