How do you turn the ABS off in a Honda Accord?
Re: How to turn off ABS? ( It is located on the passanger side under the hood on the front side of the shock/strut tower. All you have to do is take out the one Main ABS Fuse (I think it is green with a clear top if I remember right and a 30 or 40 Amp Fuse) which is screwed down by two screws.
How to reset the ABS on a Honda Accord?
4. to reset the abs ecu turn ignition off ,STEP 2 depress brake pedal,turn ignition on STEP 3,the abs light will go off after about 2 seconds. STEP 4 .after the light goes off release the pedal,the light will then come on after about 4 seconds. STEP 5 when the light comes on press the pedal again STEP.6 the light will go off again,the relase pedal.
What to do if your Honda ABS light keeps coming on?
Turn the ignition switch off, remove the key and disconnect the jumper wire from the OBD connector. If the ABS light comes back on again after step #7, do the entire procedure again, it may take a few tries to get the fault codes to clear.
How to fault reset Honda ABS and VSA?
Honda ABS / VSA Fault Reset Procedure: Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it).
How to retreive the DTC on Honda Accord?
To retreive the DTC, remove the connector from the holder and insert a paper clip into both pins. Now turn your key to the until the ABS light comes on; start counting flashes. Long flash equals 10, short flash equals 1; long pause separates distinct codes, short flashes separate numbers.
Where is the ABS light on a Honda Accord?
Look behind your glove box for a blue connector with two wires going to it. The connector will be inside a holder. To retreive the DTC, remove the connector from the holder and insert a paper clip into both pins. Now turn your key to the until the ABS light comes on; start counting flashes.
Honda ABS / VSA Fault Reset Procedure: Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it).
How do I get my Honda ABS to go off?
Now put your foot on the brake pedal and hold it down lightly while turning on the ignition switch to position “II” (all the dash lights come on, but don’t start it). The ABS indicator will come on, but then should go off, at this point release the brake pedal (some have found better success by releasing the pedal quickly after the light comes on).
To retreive the DTC, remove the connector from the holder and insert a paper clip into both pins. Now turn your key to the until the ABS light comes on; start counting flashes. Long flash equals 10, short flash equals 1; long pause separates distinct codes, short flashes separate numbers.