How do you test a Harley Davidson solenoid?
Move the voltmeter’s red probe to the solenoid’s power input terminal, located on the top of the starter solenoid. Turn the ignition switch on and shift the motorcycle into neutral. Flip the engine stop switch, located on the right handlebar, into the “Run” position, then push the starter button for two seconds.
Why is my Harley Davidson Sportster not starting?
Place your Sportster in second or third gear for the best results. A battery that can’t start your engine may no longer be recharging properly because of its age and current state of charge. The ground cables that connect the battery to your Sportster frame must also be undamaged and free of corrosion.
Why does my bike not start when I push the starter button?
Pressing the button sends power to the starter solenoid, which sends a large amount of current from the battery to the starter to turn the motor. If the engine doesn’t crank, it could be because of a failure at any of those stages, a weak battery, or a bad starter.
What should the Run switch read on a Harley Davidson Sportster?
Remove the kill switch from the right handlebar grip. Measure the resistance/continuity of the switch with the switch unpressed using the same method described for testing the run switch. The reading should be 0.1 ohms or less. Press the switch and measure again. The reading should now be “OL” or infinite, meaning no connection is present.
What to do when your motorbike wont start?
Look up direct start button cover. It can get you out of a jam when the solenoid acts up. Won’t help if the battery is to low to crank the engine though. Was this answer helpful? I dont own a motorbike.
Place your Sportster in second or third gear for the best results. A battery that can’t start your engine may no longer be recharging properly because of its age and current state of charge. The ground cables that connect the battery to your Sportster frame must also be undamaged and free of corrosion.
How to check spark plugs on Harley Davidson Sportster?
Insert a spark tester into the wire and attach the tester to ground. Remove the fuel pump fuse. Refer to the article Fuse Box Information for fuse locations. Crank the engine and watch for spark. If spark is consistently present, the problem most likely lies with the spark plugs and you should continue to Step 2.
How to check ignition resistance on Harley Davidson Sportster?
Set your meter to read ohms and place your red probe on the positive post of the coil. Place the black probe on the negative post. Your reading should be between three and four ohms. Measure the resistance of the secondary winding.
Remove the kill switch from the right handlebar grip. Measure the resistance/continuity of the switch with the switch unpressed using the same method described for testing the run switch. The reading should be 0.1 ohms or less. Press the switch and measure again. The reading should now be “OL” or infinite, meaning no connection is present.