How do you take the spring off a strut?
Use the spring compressors to compress the coil spring. Then zip the top nut off using your impact wrench. With the top nut removed, you can lift the cap off the top of the strut. With the cap removed, you can now lift the coil spring with the compressors attached free from the old strut.
Do you need a compressor to change struts?
It’s recommended that the beginner forego attempts to compress the spring on the old strut using a spring compressor or spring clamps. This method is used to save money by salvaging the old spring and installing it on the new strut, but if you don’t have your own strut compressor, it will run you $700.
What’s the best way to replace a suspension spring?
Move the lower control arm down until the spring is completely loose. Remove the spring from the vehicle. Step 7: Remove the old strut or shock. Since you’re replacing the spring, it’s a good idea to replace the strut or shock at the same time. Although this step is not required, it’s recommended by most manufacturers and ASE certified mechanics.
Do you have to change the springs on your compressor?
Rusted, damaged or cracked springs must be replaced. Do not attempt to change your springs/struts unless you fully accept the risk that the compressor, spring, strut, or jack may fail, resulting in possible injury or death.
How do you remove a strut from a spring?
Remove the large nut on top of the strut with ratchet and socket combination, and hold the strut rod with a wrench just below the strut bearing. Make a note of the strut top plate rotation before removal and reinstall in the same position. The strut can now be removed from the spring while the spring is still compressed by the spring compressor.
It’s recommended that the beginner forego attempts to compress the spring on the old strut using a spring compressor or spring clamps. This method is used to save money by salvaging the old spring and installing it on the new strut, but if you don’t have your own strut compressor, it will run you $700.
What’s the best way to replace quick struts?
Following the instructions for the spring compressor, mount the compressor to the coil spring. Note: If you are using Quick Struts proceed to Step 24. Step 13: Tighten the spring compressor. Tighten the spring compressor, alternating between sides, until the strut is loosened from the spring.
Can a spring compressor be used to remove a nut?
A good compressor either purchased or borrowed is a good idea. Much cheaper than the deductible on a trip to the ER and or dentist. Use a spring compressor. Like others have said, you can borrow one from an auto parts store. Using an impact wrench to remove and install the top nut is fine. But, you need to exercise some caution.
Rusted, damaged or cracked springs must be replaced. Do not attempt to change your springs/struts unless you fully accept the risk that the compressor, spring, strut, or jack may fail, resulting in possible injury or death.