How do you take the seats out of a Toyota Camry?
How to Remove a Backseat Out of a Camry
- Slide the two front seats forward.
- Pull the seatbelts out of the slits at the back of the cushion.
- Remove the mounting bolt from the rear seat cushion with a socket wrench.
- Locate the seat back locks and undo them by pulling them up.
How do you take apart a front car seat?
How to Remove Front Car Seat
- If you have power seats, don’t disconnect the car battery yet.
- Locate the two bolts at the back of the chair.
- Remove the two bolts on the back.
- Move the seatback.
- Remove the two bolts at the front of the seat rails.
- Next, disconnect the car battery.
- Lift the seat.
Can car seats be swapped?
Thankfully, swapping out old car seats with new ones is a relatively straightforward task – and certainly simpler than a lot of DIY car jobs. Your new set of seats should include all the brackets and allen keys required to do the job. There may also be wires for the seat heater, if one is fitted.
How do you remove a power seat from a Toyota Camry?
Remove the headrest. Remove the 4 bolts and seat. Disconnect the connectors under the seat. NOTICE: Be careful not to damage the body. Remove the 2 front seatback cover No. 2 hog rings under the seat. Using a screwdriver, remove the 2 reclining power seat switch knobs. HINT: Tape the screwdriver tip before use. Remove the 5 screws.
How to remove airbag sensor from Toyota Camry?
Driver’s seat only: REMOVE SEAT POSITION AIRBAG SENSOR Disconnect the wire harness connector. Using a torx socket wrench (T30), remove the torx bolt and airbag sensor. 17. Driver’s seat only): INSTALL SEAT POSITION AIRBAG SENSOR Temporarily install the seat position airbag sensor.
How do you remove a power seat cover?
Remove the 2 front seatback cover No. 2 hog rings under the seat. Using a screwdriver, remove the 2 reclining power seat switch knobs. HINT: Tape the screwdriver tip before use.
Do you have to wear safety gloves in a Toyota Camry?
Wear safety gloves, because the sharp surfaces of the seatback frame and seat adjuster may injure your hand. Work must be started more than 90 seconds after the ignition switch is turned to the LOCK position and the negative (−) terminal cable is disconnected from the battery. (The SRS is equipped with a back−up power source.