How do you reset the SRS light on a Honda CRV?
Put the key in the ignition and turn it on, but don’t start the engine. Keep the ends of the wire touching while you do this. The SRS light will flash on, and then disappear. Separate the wires immediately. The SRS light should come on again. Repeat Step 3 and the SRS light will blink twice and turn off.
How can I Reset my SRS warning light?
It will tell you where the problem is and allow you to reset it once the problem is fixed. Our favorite scanner that will read and reset your SRS / airbag light is the iCarsoft i980 for Mercedes-Benz which will retrieve the SRS light but also the check engine.
Is it normal for Honda SRS light to come on?
That’s partially true; however, having the SRS light come on during Honda ownership is almost an expected thing. Having the SRS light come on is so common that the original owner’s manual actually gives a briefing on how to reset it.
Is there a scanner that reads the SRS light?
Here is a scanner that works with Mercedes-Benz and will rear fault codes and reset the AirBag, ABS and check engine light. Our favorite scanner that for an in-depth Mercedes-Benz troubleshooting is the iCarsoft MB II. Not only does it read the SRS light (Airbag Control Unit) but also every control unit in your Mercedes-Benz.
Put the key in the ignition and turn it on, but don’t start the engine. Keep the ends of the wire touching while you do this. The SRS light will flash on, and then disappear. Separate the wires immediately. The SRS light should come on again. Repeat Step 3 and the SRS light will blink twice and turn off.
How do you turn off the SRS light?
MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.
Where is the fuse for the SRS light?
In most models, this is fuse #40, located in the lower right corner of the fuse block. Turn the ignition switch to “ON” without starting the engine. Leave the ignition on for about one minute to allow the system a chance to reset. Turn the ignition off.
That’s partially true; however, having the SRS light come on during Honda ownership is almost an expected thing. Having the SRS light come on is so common that the original owner’s manual actually gives a briefing on how to reset it.
What does the SRS light on a Honda do?
The secondary restraint system, or SRS, is a safety system in your Honda that controls the airbags, among other things. You would imagine that when the SRS light comes on, that it would be a big deal and need to be checked out immediately.