How do you reset the gas light on a Jeep Cherokee?
When You turn the gas cap counter-clockwise You will continue to turn the cap until it clicks three times to make sure it is fastened tightly. Now You turn on the engine and drive the SUV around for about 10 minutes and the OBD-II system will automatically reset the gas cap light.
How does the fuel gauge on a jeep work?
The fuel gauge on your Jeep is powered by the fuel sensor relay. If the fuel gauge in your Jeep stops working, the relay has gone bad and needs to be replaced. The fuel sensor relay is responsible for powering the sensors that, in turn, relay information to your fuel gauge.
Why does my car’s fuel gauge keep resetting?
Electronic and software malfunctions may cause the fuel gauge in your automobile to inaccurately measure or display the amount of fuel remaining in the gas tank. If this happens, reset your fuel gauge. Each make and model of car has its own specific instructions on how to reset the fuel gauge, but the process is basically the same.
Where is the fuel sensor relay on a Jeep Cherokee?
Lift your Jeep’s hood and remove the negative battery cable. If your model Jeep has them, unclasp the two clamps that hold the relay panel lid on. Do this by hand. The main relay panel is located near the battery. Pull the relay panel lid off. Pull out the old fuel sensor relay.
Where is the reset button on a Jeep Cherokee?
Find the Data Link Connector port next to the fuse panel under the driver’s dashboard. Plug the computerized scan tool into this port. Check the computerized scan tool’s owner’s manual on exactly how to clear the codes and reset the computer because each model is a little different.
How do you change the fuel gauge on a jeep?
Pull the relay panel lid off. Pull out the old fuel sensor relay. If you are unsure of its location, consult the relay diagram on the inside of the relay panel’s lid. Plug the new sensor in and replace the relay panel lid. Replace your Jeep’s negative battery cable.
Lift your Jeep’s hood and remove the negative battery cable. If your model Jeep has them, unclasp the two clamps that hold the relay panel lid on. Do this by hand. The main relay panel is located near the battery. Pull the relay panel lid off. Pull out the old fuel sensor relay.
How to reset service on a Jeep Grand Cherokee?
Use the STEP button on your center console pressing it till the MILES TILL SERVICE is displayed. 3. Press and hold the RESET button to the left of the STEP button for 4 seconds. Loading…
Electronic and software malfunctions may cause the fuel gauge in your automobile to inaccurately measure or display the amount of fuel remaining in the gas tank. If this happens, reset your fuel gauge. Each make and model of car has its own specific instructions on how to reset the fuel gauge, but the process is basically the same.