How do you reset the check engine light on a 2006 Honda Odyssey?
Registered
- Turn off the engine.
- Press and hold the select/reset button in the instrument panel, then turn the ignition switch ON(II).
- Hold the button until the indicator resets (approximately ten seconds).
How do you turn off the check engine light on a Honda Odyssey?
Push and hold down the “select/reset” button for approximately 10 seconds until the maintenance-required light starts to blink on and off. Push and hold the “select/reset” button for about five more seconds until the maintenance light resets.
What does the Check Engine light mean on a Honda?
The check engine light is a light that the engine computer uses to signify that there is something wrong. They are orange, amber, or yellow, and not to be ignored! The only way to “reset” the check engine light is by fixing the problem causing it. Thus, the 10 reasons I list below may help you reset your check engine light.
What should I do if my check engine light comes on?
Eddie spent 35 years in the automotive business with Honda. He is an ASE Certified Master Technician and has bruised knuckles to prove it. What should you do if your check engine light comes on?
Where is the oxygen sensor on a Honda?
The oxygen sensor is located under the vehicle, usually in or near the catalytic converter where the temperature can exceed 600 degrees. If this sounds like your scenario, take your car to the dealer or your local mechanic.
What causes Honda Odyssey check engine light to go off?
This is arguably the worst year for the Honda Odyssey with his engine problems. Many drivers experienced engine mount failure, blown spark plugs, problems with the crankshaft breaking camshaft position sensors, oil leaking issues and more. Any of these problems could have led to the check engine light going off.
Are there any problems with the Honda Odyssey?
The 2011 Honda Odyssey was reported to have some problems for some drivers as did the 2012 Honda Odyssey and the 2014 Odyssey as well. Blown spark plugs were a big problem for the 2005 Honda Odyssey, and overall, that was one of the worst years for the Odyssey across the board.
What does the O2 sensor on a Honda Odyssey mean?
Your O2 sensor is used to measure the amount of oxygen in your car’s exhaust that has not been burnt. This allows your computer to properly regulate the air/fuel mixture in the combustion reaction. If the O2 sensor goes off, you’re going to end up burning more fuel than you should.
Where is the Check Engine light on a Honda?
Turn the key into the “off” position if either of these occurs. Figure 1. A steady check engine light. (Related Article: Warning Lights – Honda-Tech.com) In the passenger’s side foot well, remove the kick panel by the side door. This will allow you access to the Engine Control Unit (ECU) and jumper plug (service connector).