How do you reset a 2009 Honda Pilot?

Press the “SELECT/RESET” knob until the engine life indicator is displayed. Press the “SELECT/RESET” knob for more than 10 seconds, the indicator and the maintenance code(s) will blink. Press the “SELECT/ RESET” knob for 5 more seconds, the maintenance code(s) will disappear and oil life will be reset to 100.

How do you reset the dash lights on a Honda Pilot?

Clear it with these steps.

Turn the ignition switch to the “OFF” position.
Press and hold the “Select/Reset” button on the instrument panel.
While continuing the hold the “Select/Reset” button, turn the ignition “ON“.
Still continue to hold the button(s) for 10 seconds or until the Maint Reqd indicator resets.

How do you reset Honda lights?

Turn the ignition key to the “on” position while still depressing the reset button. Hold the button until the light turns off. Turn off the vehicle and wait 60 seconds. Start the engine and verify that the warning lights have turned off.

How do you reset a 2009 Honda?

Turn the ignition to run (one position before starting engine). Press the SELECT/RESET button until the engine oil life indicator is displayed. Press the SELECT/RESET button for more than 10 seconds. The engine oil life indicator and the maintenance code(s) will blink.

What type of oil does a 2009 Honda Pilot take?

Honda recommends to always use a premium-grade 5W-20 detergent oil displaying the API Certification Seal for the 2009 Honda Pilot. The 2009 Honda Pilot engine oil capacity is 4.5 US quarts (4.3 liters).

How do you reset the computer on a Honda Pilot?

Honda: How to Reset Your ECU

Step 1 – Locate and open the fuse box. Open the hood and look for the fuse box, which is located near the passenger’s side.
Step 2 – Remove the applicable fuses.
Step 3 – Re-install fuses and test.

When to reset the oil change light on a Honda Pilot?

The Oil Change Light Reset Honda Pilot 2006 2007 2008 2009 2010 2011 will need to be performed after every oil change. If it is not reset the system will be unable to properly track when your next oil change is due. Below is the Oil Change Light Reset procedure for the Honda Pilot 2006 2007 2008 2009 2010 2011 .

How do you reset the oil life on a Honda Accord?

Press the “SELECT/RESET” knob until the engine life indicator is displayed. Press the “SELECT/RESET” knob for more than 10 seconds, the indicator and the maintenance code (s) will blink. Press the “SELECT/ RESET” knob for 5 more seconds, the maintenance code (s) will disappear and oil life will be reset to 100.

When to reset the Check Engine light on Honda Civic?

Continue reading to learn how to reset this light and save yourself the dealership cost. This article applies to the Honda Civic (1992-2000), and Accord (1990-2002). The check engine light in your Honda offers important diagnostic information, which will alert you of a serious problem like a bad catalytic converter.

Where is the Check Engine light on a Honda?

Turn the key into the “off” position if either of these occurs. Figure 1. A steady check engine light. (Related Article: Warning Lights – Honda-Tech.com) In the passenger’s side foot well, remove the kick panel by the side door. This will allow you access to the Engine Control Unit (ECU) and jumper plug (service connector).

What causes reset VSA light and indicator Honda Pilot?

Searched web for two days w/o success. Finally took it to dealer. They Quote “Scanned for DTC’s and found Code 84-1 Sensor Logic Failure due to possible battery disconnect and/or low voltage. Battery sensor not calibrated. Reset TCS light and calibrated system.” Unquote. Of course, I had to foot the bill for the diagnostics & labor.