How do you replace the starter on a Toyota 4Runner?
Replace the cable bolt and boot cover. Reinstall the transmission fluid dipstick, and brake line with your 12mm ratchet or wrench. Put the intake tube back in place up top. Replace the splash guard, re-mount your wheel and snug the lugs before dropping the truck. Once on the ground, tighten and torque the lugs.
Why is my Toyota 4Runner not turning over?
If you can’t get your 4Runner to turn over, or it cranks very slowly, it could be a bad starter. If the battery tests good, and all the wiring looks good, the next logical cause is the starter itself. It’s also a possibility that the starter could still be good, but it may just need a good cleaning.
How do you remove a starter from a car?
Remove the mounting nuts or bolts securing the starter motor to the transmission bell housing using a wrench or ratchet and socket. Pull the motor towards the front of the vehicle and lift the starter away from the engine compartment.
What should I do with my Toyota 4Runner?
Park your Toyota 4Runner in safe place and level surface. Open the hood and disconnect the black, negative battery cable. Raise the vehicle using a floor jack and support it safely on 2 jack stands. Remove the engine splash shield from underside the engine compartment if your particular model is equipped with one.
Where is the starter located on a 2nd Gen truck?
Figure 3. Starter location through wheel well. (Note: This is a 2nd gen truck.) Remove the two 12mm bolts that secure the brake line to the frame, and move aside the brake line. Remove the plastic intake tube between the intake manifold and the air box, so you have better access to the starter from above.
What kind of engine does a Toyota 4Runner have?
This how-to covers all 3rd generation Toyota 4Runners from 1996 to 2002 equipped with the V6 motor and automatic transmission, whether 2WD or 4WD. Four cylinder trucks are slightly different.
How do you jack up a Toyota 4Runner?
Loosen the lugs on your passenger side wheel before you jack up your truck. Use a hydraulic floor jack to lift your truck and place on jack stands in the approved locations. Figure 1. 4Runner jacking and jack stand points. Figure 1. Always use the approved jacking points to lift your 4Runner. Always use jack stands when working under your truck.
How can I repair my Toyota Tacoma starter?
In order to repair your starter you will replace the worn out solenoid contacts and plunger. [FONT=”]I had previously repaired the starter on my 4Runner with the 3.4 engine and it was pretty tough.