How do you replace the oil pump on a Toyota Camry?
Crank on the tensioner bolt to create some slack in the timing belt for easy removal. The idler is the smooth rounded pulley and must be removed to get to the oil pump. Use a wrench on the bolt in the center to remove the idler. Figure 9. Remove the idler to get access to the oil pump.
Where is the oil pump located in a Toyota?
Without this lubrication, the engine wouldn’t run. An oil pump is usually located in the oil pan. If you want to change the oil pump and replace it with a new one, roll up your sleeves and get ready for some dirty work. Position a drain pan under the oil drain and remove the drain plug with a socket wrench.
How do you change the oil pump seal?
Carefully use a screwdriver to free the oil pump cover from the oil pump body and remove all of the old o-ring gasket. You can change the oil pump seal at your workbench but I didn’t change mine because the nut on the oil pump shaft is on pretty tight and I didn’t want to chance mangling the belt sprocket using a vise to hold it from turning.
Can a oil pump sprocket be removed from a Camry?
With the crankshaft sprocket removed, you can now change the oil pump seals. If you are going to just replace the entire oil pump, the camshaft sprocket (on the left) will also have to be removed using the adjuster tool to protect those sprockets.
What causes an oil leak in a Toyota Camry?
Again, the most likely source for oil pressure loss and oil leaks are a result of these seals being work, cracked, or broken. Use a soft plastic putty knife to remove them and scrape away the old seal residue before inserting the new seals.
When do you need a new oil pump?
If you have a serious oil leakage problem, especially when idling, you likely need a new oil pump. This article applies to the 4th Generation Toyota Camry (1997-2001). Oil leaks are no fun at all, either to diagnose or to repair.
Remove the crank bolt and the crank pulley (make sure you mark the TDC on the crank pulley gear to match back up when replacing). Once the crank pulley is off, it will expose the 10mm lower timing cover bolts. Remove those bolts.
How do you replace the seal on a Toyota Camry?
The inner seal is a small O-ring type of seal. This is a little trickier to remove and replace, but isn’t too difficult. The outer seal is quite a bit bigger, but should pop in cleanly and easily once the old one is removed. Use a plastic putty knife or scraper to make sure you get all the old seal remnants out of the seat.
How do you change the oil in a Toyota?
Drain the engine coolant as well as the engine oil. Take the engine out of the vehicle and safely store it in a suitable holding device.
How to replace an oil pump in a Toyota Tacoma?
How to Replace an Oil Pump in a Toyota Tacoma. Put in a new front case oil seal then insert a new O-ring onto the left cylinder head. Apply continuous beads of seal packing (0.12 to 0.16 inches in diameter) using part number 08826-00080 on all the parts except the water pump. Add the timing chain case cover bolts,…
Can a Toyota Camry have an oil leak?
This article applies to the 4th Generation Toyota Camry (1997-2001). Oil leaks are no fun at all, either to diagnose or to repair. But no matter how small, they should never be overlooked. Some oil leaks can be innocuous enough, either a bad oil filter gasket or even an oil pan gasket.
Do you have to replace the oil pump seals?
Replacing the oil pump seals will likely solve your problems and cost much less than replacing the entire oil pump. Once the seals are replaced, put her back together in reverse order: Replace the crankshaft sprocket. Replace all the oil pump bolts to their original position. Replace the idler.