How do you replace the ignition switch on a jeep?
Disconnect the two electrical connections from the back of the ignition switch. Unscrew the Torx screw on the ignition switch. Depress the locking tab on the ignition switch and remove the switch from the steering column. Place the new switch into the steering column. The tab will lock into place when you push the switch into the column.
Where is the ignition button on a 1998 Jeep?
The flasher button gets broken very easily, so be careful not to place too much pressure on it as the cover is removed. Place the ignition key in the tumbler and turn it to the “On” position. With the small Phillips screwdriver or the scribe, stick it into the hole in the ignition switch, located directly behind the tumbler.
How do you remove the ignition switch from a car?
Remove the ignition switch. Unscrew the bolts on both sides of the ignition that hold it in place with a ratchet and socket. Use your hand to pull the ignition switch from the actuator rod. The actuator rod is what holds the ignition switch to the base of the steering wheel. Release and remove the switch completely from the steering wheel base.
Where is the release pin on an ignition switch?
The new or rebuilt switch should slide easily back into its hole on the steering column. Align the shape of the cylinder and the location of the release pin with the coinciding grooves in the ignition module.
How to remove an ignition swich from a Jeep CJ7?
Using a few simple tools, you can remove an ignition switch from a Jeep CJ7, test the wiring harness and replace the ignition switch if necessary. Locate the ignition switch by inserting the key into the ignition, looking under the dash at the top of the steering column and then turning the key. When you turn the key, you’ll see a rod move.
Why is the ignition switch on my Jeep not working?
Sometimes Jeeps won’t start but all the electronics work. It might be a faulty ignition switch keeping your Jeep from starting. This video is a how-to for replacing the Start Ignition Switch Actuator Pin; a known weakness in our beloved Jeeps. If you aren’t sure why your Jeep won’t start, this probably IS NOT your issue because it is rare.
What’s the best way to change an ignition switch?
Reconnect the cable to the negative (-) terminal on the battery, then insert the key into the ignition and turn it to start the vehicle. The vehicle should start without any issue.
The new or rebuilt switch should slide easily back into its hole on the steering column. Align the shape of the cylinder and the location of the release pin with the coinciding grooves in the ignition module.