How do you replace the headlight assembly?
Instructions
- Step 1: Remove the old headlight assembly.
- Step 2: Disconnect the assembly.
- Turn the headlamp retainer ring counter-clockwise to remove it from the headlamp.
- Step 3: Disconnect electrical.
- Step 4: Remove old assembly.
- Step 5: Replace the assembly.
- Step 6: Connect the new assembly.
Do you need to replace the whole headlight assembly?
Don’t forget bulbs and replacement wires in case you don’t need to replace the whole headlight assembly or if you just like to keep spares on hand for a quick fix in a pinch. Browse through tools and maintenance parts available to buy or rent to ensure you have everything you need to keep your vehicle safe and running well.
How do you replace a Mercedes Benz headlight?
Low (Xenon) Beam Bulb: Squeeze the retaining springs and unclip them from the headlight. Pull the headlight bulb out of the socket and replace it with a new bulb. Reverse the steps for installing. Be sure that the bulb is properly seated in the socket before trying to install it into the headlight.
Where to buy the cheapest headlight assemblies?
Enjoy some of the lowest prices on headlight assemblies anywhere, so you can maintain and repair your vehicle without breaking the bank. The wide selection both online and in-stores has everything you need when you want to work on your car.
Can a Mercedes Benz headlight bulb wear out?
If you are trying to diagnose a problem with a Xenon bulb, swap parts from side to side, as it is dangerous to attempt to test the high voltage output of the Xenon bulb parts. The headlight assembly seals can wear out over time resulting in water leaks and repeat bulb failures.
How do you change a headlight assembly on a car?
Position the assembly so that the bracket tabs are aligned with their slots and slide the headlamp inward to engage the tabs. Replace the two bolts at the top of the assembly. If you’re replacing both assemblies, repeat these steps on the other side.
How do you remove a headlamp bracket from a car?
Locate the two bolts on the top of the assembly and remove them with your wrench or socket. Set them some place safe. Now you should be able to gently slide the entire assembly out enough to release the headlamp bracket tabs from their slots on either side.
How do you change the headlamp wiring harness?
Transfer the headlamp wiring harness to the new assembly by removing the screw to make room like we did on the old assembly. After securing the bulbs in their sockets, they can be inserted into the new assembly. Secure the headlamp by turning the retainer ring clockwise onto its socket.
How do you change a parking light assembly?
Reconnect the electrical connectors to the headlamp and parking light sockets. Position the assembly so that the bracket tabs are aligned with their slots and slide the headlamp inward to engage the tabs. Replace the two bolts at the top of the assembly.