How do you replace master cylinder on Honda Accord?
How to Replace a Master Cylinder on a Honda Accord. Remove the two electrical connectors that are attached to the master cylinder on your Honda Accord. Push in the tabs on the sides of the connector, then pull the connector away from the master cylinder.
How do you mount a new master cylinder?
Pull out the old master cylinder and put the new one in its place. Mount the new one in place using the 12 mm bolts you removed. Tighten these with the socket wrench. Attach the brake lines you disconnected in Step 2 to the new master cylinder. Begin threading these by hand, then use the line wrench to tighten them.
How do you fill a master cylinder with brake fluid?
Fill the master cylinder with new brake fluid and thread the bleeder fittings into the brake line ports by turning them clockwise by hand. Install the rubber tubes onto the fittings and secure the tube ends in the master cylinder filler opening. Make sure the ends of the tubes are completely submerged.
How do you get brake fluid out of Honda Accord?
Remove the two electrical connectors that are attached to the master cylinder on your Honda Accord. Push in the tabs on the sides of the connector, then pull the connector away from the master cylinder. Use a 10 mm line wrench to open the two brake lines connected to the side of your master cylinder. Some brake fluid will spill out of them.
How do you replace a brake master cylinder?
Put the new brake master cylinder in place of the old cylinder. Connect the mounting bolts with a socket wrench. Tighten to prescribed torque or at least as tight as the old ones were. Fill the fluid reservoir with fluid allowing some to run out the brake pipe holes. Get somebody to gently pump the brakes while holding a container under the holes.
Where is the master cylinder located on a car?
The brake master cylinder is typically located directly beneath the brake fluid reservoir. Remove the brake fluid from the brake fluid reservoir. Remove the cap. Use a siphon or turkey baster to remove the brake fluid. Dispose of or recycle the brake fluid in accordance with local laws and regulations.
How to Replace a Master Cylinder on a Honda Accord. Remove the two electrical connectors that are attached to the master cylinder on your Honda Accord. Push in the tabs on the sides of the connector, then pull the connector away from the master cylinder.
How do you plug in a new master cylinder?
Attach the electrical connectors to the new master cylinder by pushing them into the appropriate ports. Each connector only fits into one of the ports; just attach each one to the port that fits. Press the brake pedal a few times until you have a firm pedal. Open the hood and prop it up with the hood support rod.