How do you replace a high beam bulb on a Honda Civic?
If you are replacing the high beam bulb, remove the smaller rubber seal. If you are replacing the low beam bulb, remove the larger rubber seal. Unclip the hold-down wire from the headlamp assembly and move it out of the way to access the bulb. Pull the bulb out of the vehicle and use a clean rag to install the new bulb.
What happens if your Honda Civic has a malfunctioning light?
Malfunctioning headlights result in reduced road vision and oncoming drivers may not be able to see your vehicle on the road. In addition, most states will issue fines for driving with faulty lights.
Why are the low beams out on my Honda Accord?
2005 Honda Accord. Replaced the fuses even though fuse looked good. Took it in to have bulbs replaced but still did nothing. Went on vacation for about 2 weeks, car was in the garage. Came back used it first night everything fine. Next day went to turn on headlights and both were out, but high beams worked.
What are the fuses for Honda low beams?
In the fuse box, as shown in the picture: Left-low beam is fuse F1, right-low beam is F6. Also look at the two 40amp fuses, marked F15 and F19. These two 40 amp fuses feed the other fuses.
How to troubleshoot headlights on a Honda Civic?
Move the hold-down wire back into place and reinstall the rubber seal over the back of the headlight assembly. Reattach the electrical connector and, if replacing the driver’s side light, reinstall the power steering reservoir. Test the headlights. If they are still not working, the issue may be with the headlight fuse.
Where is the fuse box on a Honda Civic?
The interior fuse box is underneath the steering column. To open it, turn the knobs as shown. The under-hood fuse box is located in the engine compartment on the passenger’s side. To open it, push the tabs as shown.
What are the relays on a Honda Civic?
Fuses and relay Honda Civic 2001-2006 R1 Engine coolant blower motor relay R2 AC compressor clutch relay R3 Heated rear window relay R4 Heater blower relay R5 Headlamp relay – RH