How do you remove the battery from a Jeep Liberty?
Remove the Battery
- Open the hood to access the engine compartment.
- Remove the cap over the positive battery terminal.
- Loosen the terminal by turning the nut counterclockwise with a small wrench or crescent wrench.
- Repeat the same procedure for the negative terminal.
- Locate the bolt at the rear bottom of the battery.
How do you remove the battery from a Jeep Grand Cherokee?
Use a stool to reach it if you can’t work comfortably standing on the ground, because it’s pretty high on a Jeep Grand Cherokee. Loosen the bolt on the black negative battery cable first with a box wrench or cable clamp pliers. Wiggle the cable end off the post and tap it gently with a small hammer if it won’t budge.
How to replace your Jeep Wrangler battery and upgrade?
Quadratec Extreme Duty Battery Terminals and Optima Battery Upgrade. If you’re replacing your Jeep battery with a new one, take the 10mm bolt out of the hold down clamp in the lower front and remove it entirely. Drop the new battery in place, center it, and tighten the clamp back down. If you’re reusing your battery,…
Where is the battery located in a Jeep Liberty?
The battery in the Jeep Liberty is similar to most vehicle batteries as it has a side-post terminal. That means that the battery cables both hook to the side of the battery instead of the top. Open the hood to access the engine compartment. The battery is midway up the driver’s side of the engine compartment.
How do you remove a battery from a car?
Locate the bolt at the rear bottom of the battery. Ratchet the bolt loose with a socket wrench. This will free the battery for removal. Lift the battery out of the engine compartment. Contact a parts store for proper disposal of the battery.
Quadratec Extreme Duty Battery Terminals and Optima Battery Upgrade. If you’re replacing your Jeep battery with a new one, take the 10mm bolt out of the hold down clamp in the lower front and remove it entirely. Drop the new battery in place, center it, and tighten the clamp back down. If you’re reusing your battery,…
Why do I need to remove the battery from my Jeep Liberty?
There are several reasons to remove the battery from a Jeep Liberty. You may be replacing the battery for a fresh one. You may be doing maintenance around the fuse block and need the battery removed for easier access. The battery is under the hood and allows for a simple and clean removal.
Locate the bolt at the rear bottom of the battery. Ratchet the bolt loose with a socket wrench. This will free the battery for removal. Lift the battery out of the engine compartment. Contact a parts store for proper disposal of the battery.
How big of a cable do you need for a Jeep Wrangler battery?
Next, move on to tighten down the two nuts that hold the brass down onto the terminals. The positive side is 9/16-inch, but you can use a 14mm. The negative side is ½-inch, or 13mm. They’re actually standard fasteners, but these metric sizes are close enough to to work. The factory cable ends go under the next ⅜-inch bolt down the rail.