How do you remove ignition switch from steering column?
Pull down on the steering column cover to remove it. Slide the punch pin into the access hole on the underside of the steering column. Turn the ignition key to the “II” position. Push in on the punch pin and pull the ignition switch and cylinder assembly out of the steering column. Then remove the pin from the access hole.
What’s the best way to remove an ignition switch?
Remove them carefully by either popping them off of their plastic clips or removing the screws and bolts that hold those pieces in place. Refer to a vehicle specific repair manual for guidance on how best to gain access to the ignition switch. Set all trim pieces aside somewhere safe where they won’t get stepped on or damaged. Helpful?
When does the ignition switch need to be set?
The ignition switch needs to be set to the accessory position before you can release it from the ignition module. The “accessory” position is before the starter is engaged, and would normally let you run the vehicle’s electronics without the engine running (when the battery is connected).
What to do if your key is stuck in the ignition switch?
The key may be stuck in the ignition switch, but that shouldn’t stop you from turning it. If you don’t have a key, you will need to force the module to turn using a flathead screwdriver. Press the release pin inside the hole on the ignition module with a screwdriver.
How to remove the ignition switch without a key?
How to Remove the Ignition Switch Without a Key. 1 Step 1. Turn on your power drill and use your drill bit to make a hold in the key slot of the ignition cylinder. Be sure to make the hole large enough 2 Step 2. 3 Step 3.
Where is the starter switch on my car?
These switches are located just to the side of the steering wheel and column on your dashboard, and are one of the main components in your car’s starter system. If the switch is not working, you will likely have to remove and replace it. You can do this with a set of simple tools like a screwdriver.
Where is the ignition switch on a car?
These switches are located just to the side of the steering wheel and column on your dashboard, and are one of the main components in your car’s starter system. If the switch is not working, you will likely have to remove and replace it.
Do you have to take steering wheel out to replace ignition switch?
Take the steering wheel out if it’s in the way. In some vehicles, you may be able to replace the ignition switch without removing the steering wheel. However, if you’re unable to get access to the top of the ignition switch with all the interior trim pieces removed, the steering wheel may need to come out.