How do you remove an old serpentine belt?
To remove an old serpentine belt, or to tighten up a new one, the tensioner bolt on the tensioner pulley is turned until proper tightness is achieved. Please see your repair manual for the recommended tension on your vehicle’s engine.
What happens if a serpentine belt goes bad?
The serpentine belt in most modern vehicles transfers power from the crank pulley to the various accessories mounted on the engine. A worn or damaged serpentine belt can fail to adequately transfer the power, leaving your alternator, power steering, and air conditioning failing to function.
Can a serpentine belt be replaced by a timing belt?
For example, select older rides may have a series of V belts in place of the serpentine belt. Some cars also have a timing belt to drive water pumps and oil pumps to the engine and other important parts. Can Sun Auto Service Replace My Serpentine Belt?
Which is the smooth side of the serpentine belt?
The kind of serpentine belt diagrams you will see on our site will be easily understandable diagrams for your make and model vehicle. The serpentine belt track to the right uses a tensioner and is from a 7.4L big-block. Notice that the smooth side of the belt is always against the smooth surface of the pulley.
When should you replace the serpentine belt?
Most serpentine belts need to be replaced every 40,000 to 70,000 miles. If there are signs of the belt rubbing on something, make sure to identify and repair whatever it was rubbing on to avoid damaging the new belt.
How do you remove a serpentine belt?
To remove the serpentine belt, release tension off of the tensioner. Then grab the serpentine belt between the a/c compressor and alternator just pull it off. You do not need to take it far off.
What are the symptoms of a bad serpentine belt?
Symptoms of a Bad or Failing Serpentine/ Drive Belt . Common signs include a squealing noise from the front of the vehicle, power steering and AC not working, engine overheating, and cracks on the belt.
How do you know if your serpentine belt is too tight?
If you notice any whine or “pulsing” sound from the alternator, your belt tension is too tight and will damage the alternator. In this case, turn the adjustment screw counterclockwise to loosen the belt and recheck the tension. Do a final check. You can also check for continuous power from all your accessories.