How do you remove a tire hub?
How to Remove a Wheel Hub
- Remove the wheel and brake caliper assembly and set them aside so that you have working space around the wheel hub.
- Locate the small, rounded cap in the center of the hub.
- Use the screwdriver and/or pliers to pull out the cotter pin from the slotted nut that is in the center of the hub.
How do you change a rear wheel oil seal?
To replace the seal, take the following steps:
- Jack up one side of your truck to take the weight off the wheel.
- Remove the wheel.
- Remove the axle shaft.
- Remove the hub retaining hardware.
- Slide off the hub and drum as a unit.
- Replace the seal behind the hub.
- Put everything back together in the reverse order of removal.
How to replace rear wheel bearing and hub Toyota Corolla?
How to replace rear wheel bearing and hub Toyota Corolla. Years 1991 to 2002 – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
How do you remove a stuck rear wheel hub?
After knocking out the studs, I put the bolts through two holes on the hub (washers were used to keep them from pulling all the way through). I threaded a nut up the other side, held it with an open-face wrench, and turned the bolts against the back-plate – alternating between the two, to keep the assembly straight on its way out.
How do you replace a wheel seal on a Toyota?
You should be able to remove and install this seal by hand. Just pop it out, push the new one in, and apply grease to the seal lip. To begin reassembly, place the backing plate onto the axle shaft, then the new wheel bearing, and then the bearing retainer.
When did Toyota stop using manual locking hubs?
Toyota used the exact same hubs from 1979 – 1985 trucks ( Hilux ) and 4Runners with only minor changes from 1986 – present. Loading…