How do you remove a serpentine belt from a Chevy Silverado?
In order to remove the belt from the pulleys, you will need to release this tension, which will slacken the belt and allow you to remove it from the rest of the pulleys. There should be a 3/8-inch drive square hole in the middle of the tensioner.
Where do I find the serpentine belt on my car?
To access the serpentine belt, you will need to open the hood of the vehicle. The hood release can usually be found near the door on the driver’s side of the vehicle. With the hood released, you will also need to release the safety latch located at the front of the vehicle.
How is the tension set on a serpentine belt?
Depending on the application, your serpentine belt will either have tension placed on it using a movable bracket or an auto tensioner pulley. This pulley uses an internal spring to apply consistent pressure to the belt at all times. If your vehicle does not have a tensioner pulley, the alternator bracket is likely how tension is set on the belt.
How often should a serpentine belt be replaced?
Without this belt, the engine cannot function correctly. It is recommended that the belt be checked every 6,000 miles or six months, and replaced when necessary. Figure 1. Shredded serpentine belt.
In order to remove the belt from the pulleys, you will need to release this tension, which will slacken the belt and allow you to remove it from the rest of the pulleys. There should be a 3/8-inch drive square hole in the middle of the tensioner.
How to tell if your serpentine belt needs to be replaced?
Look for signs of damage or wear on the belt. Once you have located the serpentine belt, inspect it visually for signs of damage. If the belt is frayed, coming apart, or has marks that indicate that it has been rubbing on something, it will need to be replaced.
What kind of pulley does a serpentine belt use?
Determine if there is a belt tensioner pulley. Depending on the application, your serpentine belt will either have tension placed on it using a movable bracket or an auto tensioner pulley. This pulley uses an internal spring to apply consistent pressure to the belt at all times.
Where do I find the serpentine belt routing diagram?
Find the serpentine belt routing diagram. Many cars come with a sticker in the engine bay that shows exactly how the serpentine belt is supposed to be routed through the various pulleys on the engine. If your vehicle does not have a sticker, you will need to find another way to remember how the belt should be run.
How to change a serpentine belt on a 2003 Chevy Silverado?
Put the ratchet and socket onto the tensioner bolt head and turn the tensioner clockwise to relieve the tension on the belt. Slide the belt off at the idler pulley, which is the top center pulley above the water pump. Finish removing the belt from the rest of the pulleys.
How do you remove a serpentine belt from a battery?
Use the appropriate sized wrench or socket to loosen the nut holding the black ground cable on the negative terminal of the battery. Slide the cable off of the terminal and tuck it to the side of the battery. You will not need to disconnect the positive terminal. Locate the serpentine belt.