How do you remove a flywheel from a car?
Make sure the bolt heads aren’t catching on the flywheel during removal. If the flywheel is broken and jammed to one side, use a pry to rotate the bolt holes until they are in position to remove the bolt heads. Before removing it, note the position of the flywheel TDC mark against the engine.
How do you put a feeler on a flywheel?
Turn the flywheel shaft until the rubbing block rides up and sits upon the highest part of the shaft, which will be the lobe. Place a feeler gauge, set at .20 inch, between the two point contacts and adjust the contacts to close over the feeler gauge. Refer to your engine manual for the precise inch gap.
How to remove flywheel and timing of points ontecumseh 8HP?
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: OM0aBO6sc6hey7la)
What should I do if my flywheel is jammed?
If the flywheel is broken and jammed to one side, use a pry to rotate the bolt holes until they are in position to remove the bolt heads. Before removing it, note the position of the flywheel TDC mark against the engine. You can make a mark on the thin metal shim behind the transmission.
How do you remove a flywheel from an engine?
Remove the flywheel retaining nut from the engine crankshaft with a socket wrench while holding the flywheel with the flywheel strap wrench to prevent the flywheel from turning. Slide the recoil starter cup and washer from the crankshaft by hand.
Where do you find the points wire on a flywheel?
Let us start from the beginning. Pull the Flywheel cover and find the points wire that comes out of the top of the crankcase. It is usually a black wire with a white strip or a solid black wire but not always. Check your shop manual. When you find the points wire connect a Buzz Box to it and turn it on.
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: OM0aBO6sc6hey7la)
Turn the flywheel shaft until the rubbing block rides up and sits upon the highest part of the shaft, which will be the lobe. Place a feeler gauge, set at .20 inch, between the two point contacts and adjust the contacts to close over the feeler gauge. Refer to your engine manual for the precise inch gap.