How do you put transmission fluid in a 2006 Toyota 4runner?

The sealed transmissions (without a dipstick) have a fill plug and an overflow plug. They’re both on the trans itself, under the truck. Fill is on the side, and overflow is on the bottom. Basically, you pour ATF (probably ATF WS – check your specs) into the fill hole until it comes back out the overflow hole.

Where is the transmission fluid dipstick on a 2006 Toyota 4runner?

The transmission dipstick is located to the rear of the motor.

Where is the transmission filler located?

First, locate the transmission dipstick, which can be found under the hood, in the engine compartment. Make sure you are locating the transmission dipstick and not the engine-oil dipstick; the transmission dipstick is usually further back in the engine bay, toward the firewall (the bulkhead at the front of the cabin).

How do you check transmission fluid in a Toyota?

How to Check Automatic Transmission Fluids

Pull out the dipstick. Put the car in Neutral or Park with the braking on, and keep the car running.
Check the fluid. The transmission fluid on the dipstick should be bright red and almost clear.
Wipe the dipstick with a clean rag, reinsert it, and pull it out again.

When should I change the transmission fluid in my 5th generation 4Runner?

Change 3.5 quarts every 30,000 miles to maintain old-new mixture average fluid life under 100,000 miles. There will always be a small amount of the original WS fluid in the transmission, ~1 quart after 270,000 miles and ~1 pint after 350,000 miles.

Should I change my 4Runner transmission fluid?

The 4Runner is an SUV sold by Toyota Motor Corporation around the world. The 4Runner has a unique transmission pan that allows fluid to be changed without removing the pan. Transmission fluid should be changed every 25,000 to 30,000 miles under normal operating conditions, according to Toyota.

Does Toyota recommend a transmission flush?

Toyota recommends that vehicles featuring an automatic transmission have their fluid changed every 60,000 to 100,000 miles.

How do you put transmission fluid in a 2006 Toyota 4Runner?

How do you check the transmission fluid on a 2006 Toyota 4Runner?

Check the Transmission Fluid on a Toyota 4-Runner

Crank the 4Runner up and let it warm up briefly.
Open the hood.
Pull the dipstick out of the tube.
Locate where the fluid ends on the dipstick.
Sit in the vehicle and place the truck in gear.
Check the fluid level again, making sure the level is still full.

Do you fill transmission fluid while running?

Your car’s engine should be running when you add fluid to the transmission, but you should have the transmission in park and the handbrake activated for safety. Check the owner’s manual for instructions on selecting the correct transmission fluid for your vehicle.

How to check Toyota 4Runner 5 spd automatic transmission?

Add specified fluid until fluid trickles from the overflow tube. Install overflow plug with a new gasket; tighten to 15 ft. lbs. (20 Nm). Stop engine. Install refill plug with a new gasket; tighten to 29 ft. lbs. (39 Nm). Watch this video for more information. Loading…

How do you add fluid to a Toyota 4Runner?

To add fluid to transmission, remove the refill plug and gasket. Add specified fluid until fluid trickles from the overflow tube. Install overflow plug with a new gasket; tighten to 15 ft. lbs.

How do you drain and refill an automatic transmission?

Upon pumping the required amount into the AT with the bottle pump (or funnel and hose), replace the fill plug and start the engine. While the truck idles, move the shift lever through ALL of the gear positions to circulate the fluid. Return the gear selector to Park.

How does a Toyota 5 speed transmission work?

The drain and fill procedure on the Toyota 5 speed AT (mated to the 4.0L V6) is different than that of traditional transmissions. Since this transmission has no dipstick to check fluid level, the correct level must be confirmed by an overflow plug on the bottom of the pan.

Navigation