How do you put a timing belt on a car?
To aid in this process, you can use spring-loaded clips to hold the belts on the pulleys as the belt is routed. With the belt in place, tighten the idler pulley bolt to 38 ft.-lbs. 13. Next, remove the retaining tool or pin from the auto-tensioner. Install the engine mount bracket to the front of engine.
Can a taut timing belt stand a strong pull?
While a taut string or timing belt can stand a strong pull. Take up any loose slack in the timing belt by adjusting the center to center distance between the two timing belt pulleys. Before any final tensioning is to be applied make sure that the timing belt teeth are fully seated in the tooth grooves on both timing belt pulleys.
Where is the O / T mark on the timing belt?
At TDC for cylinder number 1, the O/T mark on the crankshaft pulley timing wheel or vibration damper (green arrow) will line up with the line on the lower timing belt cover (yellow arrow). In addition, the mark on the camshaft sprocket should line up with the mark on the cylinder head.
When to replace timing belt on Toyota V6?
I will highlight some things to look for during the procedure, some tips to save time and hassle, and some cautions that will keep you out of trouble. Toyota and Lexus recommend timing belt replacement on this engine at 90,000 miles or nine years.
How do you install a new timing belt?
Install the new timing belt over the timing belt pulleys. Do not pry or use force, loosen the motor mount and/or mounting brackets to loosely install the timing belt. NEVER PRY ON A TIMING BELT, PRYING THE TIMING BELT WILL DAMAGE THE TIMING BELT PULLEYS TEETH AND/OR FLANGE THAT YOU ARE LEVERAGING AGAINST.
How to remove timing belt on Toyota V6?
We all know that you can use a pulley holding tool and a breaker bar, but an impact wrench will easily remove the bolt, in most cases. 5. Spray some penetrating oil on the end of the shaft and pulley and either wiggle the pulley off the crank, or use the proper puller to carefully remove the crankshaft pulley.
While a taut string or timing belt can stand a strong pull. Take up any loose slack in the timing belt by adjusting the center to center distance between the two timing belt pulleys. Before any final tensioning is to be applied make sure that the timing belt teeth are fully seated in the tooth grooves on both timing belt pulleys.
Can a timing belt be removed without prying?
Loosen motor mounting bolts. Move motor until existing timing belt is slack and can be removed without prying. NEVER PRY OFF A TIMING BELT, PRYING THE TIMING BELT WILL DAMAGE THE TIMING BELT PULLEYS TEETH AND/OR FLANGE THAT YOU ARE LEVERAGING AGAINST. Remove old timing belt and check the timing belt for unusual wear.