How do you install a fuel tank on a Honda Accord?
Align the marks on the fuel tank unit and the fuel tank. (See page 11-327, step 11 of the 2003-’06 Accord V6 Service Manual Supplement.) Install the fuel tank unit into the tank without dislodging the gasket. Using hand pressure only, slide the fuel tank unit into the tank until it is properly seated.
What to do if your Honda Accord shuts off while driving?
If there is an obvious problem, the following basic diagnostic procedures could make the difference between driving your Accord home and calling for a tow truck. Modern cars use electronic systems that require power to operate. A sudden loss of power can shut down multiple systems at once. Begin your diagnosis by testing the power supply.
Why is my Honda Accord engine so hard to start?
Exhaust gas backflow into the intake manifold at engine shutdown may cause a poor mixture of intake air and fuel at the next engine start-up. Replace the fuel pressure regulator, if needed, and use the HDS to update the PGM-FI software in the ECM/PCM.
What should fuel pressure be on Honda Accord?
Start the engine, and let it idle for 2 minutes. 3. Turn off the engine. Check the fuel pressure gauge. Pressure should be 380 to 430 kpa (55 to 63 psi). 4. Monitor the fuel pressure reading. If the fuel pressure bleeds down quickly after the engine is turned off, go to the Repair Procedure.
How much does a 2000 Honda Accord weigh?
2000 Honda Accord Sedan Change Vehicle. Vehicle Specifications. Curb Weight (lbs., MT/AT): 3064/3120. EPA Mileage Estimates*/Fuel Capacity (4 Speed Automatic EX)
Why does my Honda Accord turn itself off?
1997 to 1999 Accords have a known problem with their ignition switch, which causes your cluster to die at the same time your engine cuts out. This is likely a power supply problem, and the car will turn itself off sporadically. For these Accord model years, a recall is in effect. Contact a dealership to have the ignition switch replaced.
How much horsepower does a Honda Accord have?
* 148-hp @5700/148 lb.-ft. @4900 ULEV-rated engine available in California and parts of the Northeast. **Mileage figures shown for comparison only.
How much does it cost to replace fuel pump in Honda Accord?
The cost for a new Honda Accord fuel pump runs from $70 to $100. It’s a more difficult task to replace yourself, so having an automotive mechanic do the job starts at $300 for parts and labor. Figure 4.
Align the marks on the fuel tank unit and the fuel tank. (See page 11-327, step 11 of the 2003-’06 Accord V6 Service Manual Supplement.) Install the fuel tank unit into the tank without dislodging the gasket. Using hand pressure only, slide the fuel tank unit into the tank until it is properly seated.
Start the engine, and let it idle for 2 minutes. 3. Turn off the engine. Check the fuel pressure gauge. Pressure should be 380 to 430 kpa (55 to 63 psi). 4. Monitor the fuel pressure reading. If the fuel pressure bleeds down quickly after the engine is turned off, go to the Repair Procedure.
Exhaust gas backflow into the intake manifold at engine shutdown may cause a poor mixture of intake air and fuel at the next engine start-up. Replace the fuel pressure regulator, if needed, and use the HDS to update the PGM-FI software in the ECM/PCM.
How to test the Honda Accord V6 engine?
(Refer to steps 1 and 2 on page 11-332 of the 2003-’06 Accord V6 Service Manual Supplement, or online, enter keyword Gauge Test, and select Fuel Gauge Sending Unit Test [V6 Engine] from the list.) 2. Start the engine, and let it idle for 2 minutes.