How do you install a distributor in a Jeep Wrangler?
Remove the distributor cap by unbolting it from the distributor housing. Without inserting it all the way, place the distributor over the hole (the cylinder inside is the oil pump gear shaft), and line up the mounting bolts. Rotate the rotor like a clock hand until it points to 4 o’clock, and seat the distributor. Bolt down the distributor housing.
How to replace oil pump distributor in Jeep?
Before inserting new distributor in it’s place you need to make some alignment. First, using flat screwdriver, set the oil pump shaft around 11 o’clock position: 7. New distributor preparation Then take the new distributor, put the old cap on it and mark the distributor next to the number one cylinder terminal as you did with the old one.
How to replace ignition distributor in Jeep 4.0L engine?
First – write down somewhere numbers to which cylinder which wire goes. Unfortunately there is no such info on any distributor caps I have seen. You can also print this picture: Then make a mark both on the distributor and the cap just next to the cylinder number one terminal: Now, using philips screwdriver, unbolt and remove distributor cap. 4.
When to replace the distributor in a Jeep Grand Cherokee?
How to Replace the Distributor in a Jeep Grand Cherokee. Jeep introduced the Grand Cherokee in 1993, and engines from then until 2000 contained distributors. The 2.5L and 4.0L engines had distributors all through those years, with the 5.2L and 5.9L joining the group from 1993 to 1998.
Remove the distributor cap by unbolting it from the distributor housing. Without inserting it all the way, place the distributor over the hole (the cylinder inside is the oil pump gear shaft), and line up the mounting bolts. Rotate the rotor like a clock hand until it points to 4 o’clock, and seat the distributor. Bolt down the distributor housing.
Before inserting new distributor in it’s place you need to make some alignment. First, using flat screwdriver, set the oil pump shaft around 11 o’clock position: 7. New distributor preparation Then take the new distributor, put the old cap on it and mark the distributor next to the number one cylinder terminal as you did with the old one.
How to Replace the Distributor in a Jeep Grand Cherokee. Jeep introduced the Grand Cherokee in 1993, and engines from then until 2000 contained distributors. The 2.5L and 4.0L engines had distributors all through those years, with the 5.2L and 5.9L joining the group from 1993 to 1998.
How to install a distributor and set initial timing?
Leave a little extra room with the spark plug wires to allow freedom of movement in the distributor. For Chevys, be careful to make sure 5 and 7 are installed correctly. If the wires are accidentally switched, the engine will not be happy. Before we try to start the engine, be sure the distributor is connected to switched power.