How do you get a neutral light on a grizzly?
Try holding the rear brake in (either foot or left hand) and while pulling left on the gear lever, move forward and back to see if the light will come on in any position. Sometimes you need to adjust the “tie rod” which connects the shift lever to actual tranny shift point.
When to know if your neutral safety switch is bad?
If you have set the gear to park in your automatic transmission and the engine does not crank after you turn the key in the ignition, then you probably have a problem with your neutral safety switch.
What to do if your Grizzly 700 is having problems?
Below are some things you can do to prevent these problems: Verify that the battery registers 12.5V or higher. This is a good first step, especially when troubleshooting 2008 Yamaha Grizzly 700 problems with startup. Anything below the said value is indicative of an unhealthy battery, which would mean a replacement.
Why does my Yamaha Grizzly 700 make a clanking noise?
It makes a clanking noise when in 2WD or 4WD. This problem usually happens after gassing on Yamaha quads hard. The initial speculation is that this is due to a snapped axle. Issues with bearings and axles may be the case for Yamaha ATVs that have been modded.
Where is the Kill Switch on a Yamaha Grizzly 700?
Check out our Yamaha Grizzly 700 electrical parts diagram and starting motor parts diagram for reference. Make sure the kill switch on the left handlebar side is in the “Run” position. It might seem like a “no brainer,” but it’s actually a common oversight.
Try holding the rear brake in (either foot or left hand) and while pulling left on the gear lever, move forward and back to see if the light will come on in any position. Sometimes you need to adjust the “tie rod” which connects the shift lever to actual tranny shift point.
Below are some things you can do to prevent these problems: Verify that the battery registers 12.5V or higher. This is a good first step, especially when troubleshooting 2008 Yamaha Grizzly 700 problems with startup. Anything below the said value is indicative of an unhealthy battery, which would mean a replacement.
What are the symptoms of a bad neutral safety switch?
This is another possible symptom of a neutral safety switch problem. The switch itself might still be in good shape, but it could be loose in the transmission or there could be an electrical issue that is preventing the switch from receiving power.