How do you fix an ABS pump on a sprinter?
To repair the ABS pump motor you’ll need to remove the hydraulics part of the pump from the van which is done by draining the brake fluid (see the post about bleeding the brakes ), removing the brake lines from the ABS pump and then lifting the pump from the base (it’s not bolted to the van anywhere, just plugged into a rubber base).
What is ABS code on Mercedes Sprinter 3500?
The 2006 Sprinter 3500 part number for example is A0004465789 [@eBay] The Mercedes specific ABS code that the scanner gave me was C1401 (ABS return flow pump) which led to the pump itself. First, a simple test to check if the ABS pump is working is listening closely when you turn the ignition to position 2 (not starting the engine).
Where is the brake light on a sprinter?
2. Check your brake light switch, located at the top of the brake pedal lever. if it is stuck on or intermittently sticking on the truck thinks you are trying to slow down while you have your foot on the gas. Computers don;t like these kind of messages so it thinks you have a problem. Click, on goes the light. 3.
How much does it cost to fix a Mercedes ABS pump?
As it turned out, the previous owner tried to replace a malfunctioning ABS pump with another defective one. The real fix however turned out to be pretty simple, technically speaking and surprisingly cheap – given that a Mercedes seller would charge you over $2000 for a new ABS system alone, not including labor for installing it.
What kind of brake system does sprinter 3500 have?
In the rear, there are two different brake systems on the Sprinter for the 2500 and 3500 models. The 2500 uses a single piston floating caliper, and the 3500 uses a dual piston floating caliper. Both versions use a drum-in-hat emergency brake.
To repair the ABS pump motor you’ll need to remove the hydraulics part of the pump from the van which is done by draining the brake fluid (see the post about bleeding the brakes ), removing the brake lines from the ABS pump and then lifting the pump from the base (it’s not bolted to the van anywhere, just plugged into a rubber base).
The 2006 Sprinter 3500 part number for example is A0004465789 [@eBay] The Mercedes specific ABS code that the scanner gave me was C1401 (ABS return flow pump) which led to the pump itself. First, a simple test to check if the ABS pump is working is listening closely when you turn the ignition to position 2 (not starting the engine).
What causes brake wear on a Sprinter van?
This usually results in front brake wear. In TSB 08-028-06 for first-generation Sprinters, Chrysler states that a burned out or incorrect type brake light bulb could result in unrelated DTCs in the ECM or ABS/ESP control module.