How do you create a mass floor in Revit?

How do you create a mass floor in Revit?

Create Mass Floors

1. If you have not already done so, add levels to the project. Mass floors are based on levels defined in the project.
2. Select the mass.
3. Click Modify | Mass tab Model panel (Mass Floors).
4. In the Mass Floors dialog, select each level that needs a mass floor, and click OK.

What is mass floor in Revit?

Mass floors provide geometric information about the dimensions of the mass above the slice, up to the next slice or the top of the mass. You can create a mass floor at each level defined in the project. Use this information to create rough cost estimates for the exterior of the building based on square units.

Where is mass floor in Revit?

Click Modify | Mass tab Model panel (Mass Floors). In the Mass Floors dialog, select each level that needs a mass floor, and click OK. Initially, if you select a level that the mass does not intersect, Revit Architecture does not create a mass floor for that level.

How do you create a floor schedule in Revit?

Click View tab Create panel Schedules drop-down (Schedule/Quantities). In the New Schedule dialog, do the following: For Category, click Mass Floor….Create a Mass Floor Schedule

1. On the Fields tab, select the desired fields.
2. Use other tabs to specify filtering, sorting, and formatting of the schedule.
3. Click OK.

How do you make a sloping floor in Revit?

Create a sloped floor using slope arrows:

1. If you are not already in sketch mode, select the floor in plan view, and click Modify Floors tab → Edit panel → Edit Boundary.
2. Click Modify Floors > Edit Boundary tab → Draw panel → Slope Arrow.
3. Sketch the slope arrow on the floor.
4. Select the slope arrow after drawing it.

Which floor type is used for creating floors for a mass instance?

To create floors from a mass instance, use the Floor by Face tool or the Floor tool. To use the Floor by Face tool, you first create mass floors. Mass floors calculate floor areas in a mass instance.

How do you create an area boundary in Revit?

Create Area Boundaries

1. Open an area plan view. Area plan views are listed in the Project Browser under Area Plans. See Area Plans.
2. Click Architecture tab Room & Area panel Area drop-down (Area Boundary Line).
3. Draw or pick the area boundaries. (Use Pick Lines to apply area rules.)