How do you complete a drive cycle on a Toyota Camry?
AIR-FUEL RATIO (OXYGEN) SENSOR MONITOR DRIVE CYCLE Start the engine and allow it to idle 2 minutes. Drive the vehicle at a steady speed between 40-70 mph (64-112 km/h) or more for 3 minutes. Maintain engine speed between 900 & 3,200 rpm. Stop the vehicle and allow it to idle for ten (10) seconds or more.
What is the drive cycle for a 2002 Toyota Camry?
Idle the engine in drive for two and a half minutes with the A/C and rear defroster on. Turn the A/C and rear defrost off, and accelerate to 55 mph at half throttle. Hold at a steady speed of 55 mph for three minutes.
How long does it take to reset a drive cycle?
In most cases, a correct drive cycle will take no longer than 15 minutes to complete.
How far do you have to drive to reset computer?
Here’s something you probably don’t know: after clearing the car’s computer you will need to drive for about 50 to 100 miles. As you drive your car the computer will monitor all the sensors and register the results. You can use GOFAR to constantly monitor your car diagnostics.
When does the readiness monitor complete on a Toyota Camry?
Although the drive cycle for a 2003 Toyota Camry might be slightly different, it’s worth giving it a try. As long as all the emission systems are working correctly, the readiness monitors should complete without setting a fault code (DTC) by the end of the drive cycle. 2004 Toyota Solara 2.4L 4 cyl engine. Drive Cycle for Evap, Catalyst ?
What is the EVAP drive cycle for a Toyota Camry?
According to my software the EVAP monitor drive cycle for a 2001 Toyota Camry is to: Drive at 45 mph for 5 minutes (steady) then decelerate to 25 mph for 15 minutes then back to idle. Catalyst monitor drive cycle for 2005 Toyota rav4? 2005 Toyota Rav 4 catalyst monitor drive cycle is usually relatively simple.
How to reset the OBD II drive cycle?
Decelerate without using the brake (coast down) to 20 MPH or less, then stop the vehicle. Allow the engine to idle for 10 seconds, turn the key off, and wait one minute. Restart and accelerate to 40-55 MPH at 25% throttle and maintain speed for two minutes.
Can a Toyota drive cycle complete the catalyst monitor?
The catalyst monitor on many Toyota vehicles can be difficult to complete. That’s why it’s important to follow the Toyota recommended drive cycle after performing actions that are known to clear your Toyota’s computer memory.