How do you check the codes on a 2003 Harley Davidson Road King?
6 – To get the DTC within an area of diagnostics, push and hold the odometer reset button in for 5 seconds and release. If there are any DTC’s the code will be displayed or the word “none” will appear if there are no DTC’s. Push the odometer reset button again to view additional codes if they exist.
What does low RNG mean on Harley?
“LO RNG” to indicate that the motorcycle will shortly run out of fuel. When the low fuel warning lamp turns on, the fuel level is low. Refuel as soon as possible. The range display is only updated when the vehicle is moving. The automatic fuel range display is enabled after the ignition is turned OFF IGN.
What kind of audio does a 2003 Electra Glide have?
The audio package includes an AM/FM/weatherband radio and, for 2003, a CD player. It delivers sound through four speakers (two in the fairing, and two at the front of the trunk) or optional helmet-mounted headsets.
What does the Check Engine light on a Harley Davidson mean?
The check engine light is designed for a reason; it is there to tell you that there is something wrong with your Harley Davidson Dyna Glide. The dealership will charge you over $100 to read and clear the code for you.
When did the first Harley Electra Glide come out?
It seemed fitting that the first 100th-anniversary Harley-Davidson model we sampled should be the Electra Glide, perhaps the most traditional of all Harley’s models. The “Glide” part goes back to 1949, when Harley first introduced a hydraulically damped fork, the Hydra-Glide, on its big twins.
What does the Check Engine light on a Dyna Glide mean?
The check engine light is designed for a reason; it is there to tell you that there is something wrong with your Harley Davidson Dyna Glide. The dealership will charge you over $100 to read and clear the code for you. The good news is, you can do the very same thing for free.
Can a diagnostic test wire be installed on a Check Engine Lamp?
IMPORTANT NOTE ..If diagnostic test wire is installed across Pins 1 and 2 on connector in lieu of a Scanalyzer, the ECM is placed in a diagnostic test mode and the engine will start. The test wire must be removed from the data connector and the ignition switch turned OFF or the check engine lamp will continue to flash codes.
How do you know if your Harley Davidson has a trouble code?
The test wire must be removed from the data connector and the ignition switch turned OFF or the check engine lamp will continue to flash codes. A historic trouble code resides in the memory of the ECM until the code is cleared by use of the Scanalyzer or a total of 50 trips has elapsed.
How to install diagnostic test wire on Electraglide?
Install diagnostic test wire/clip across Terminals 1 and 2 on the data link connector, they are marked. c. Turn Ignition/Light Key Switch to IGNITION and wait approximately 10 seconds (4 seconds lamp ON, 6 seconds lamp OFF) for check engine lamp to start flashing.