How do you charge a BMW GS 1200 battery?
Charging the Battery on a 2016 R1200GS?
- Turn the ignition of the motorcycle to “ON.” ( Do not start) Connect the battery charger to the “On Board Socket” first, then connect the charger to the 110 volt outlet.
- Turn the ignition of the motorcycle to “ON.” ( Do not start)
How do you trickle charge a BMW motorcycle battery?
BMW Trickle Charger
- plug the charger into wall outlet.
- turn on bike ignition.
- connect charger to aux socket.
- wait 5 seconds then turn ignition off.
Can you wheelie a BMW GS?
When standing you can use your weight to preload the front, then when you unload it make certain the power is hitting the rear wheel at the exact time. Sounds easier than it is, but once you get your timing down, its very easy to wheelie the 1200, even in second, low rpm, with no clutch.
How do you charge a BMW R1200GS battery?
Pull off the battery cover, revealing the negative terminal end of the battery and a nearby post with a red plastic cover. Hook up a Battery Tender with alligator clips, black to negative terminal, red to post where the red cap had been. That’s it.
Can a BMW battery be charged through a pillion seat?
If you want to charge your battery via an aux on-board socket (e.g. under edge of pillion seat only chargers specifically approved for this mode of charging can be used (BMW battery charger only?).
How long does a BMW 1200gs battery last?
Just 6 weeks short of the expiry of the 2 year warranty on the replacement battery its also failed and been replaced (no cost thanks to the warranty but if you buy a battery from a BMW Dealer they’re now £95!! [Feb2010] :-0 ) Many 1200GS owners report even shorter life of batteries!!
Do you need a charger for a BMW?
If the power outlet is pigtailed directly to the battery instead of going through the CANbus, you don’t need any fancy BMW charger. Usual pigtails from the battery are 2 prong SAE connectors, and most battery tenders come with a wire for that.
Pull off the battery cover, revealing the negative terminal end of the battery and a nearby post with a red plastic cover. Hook up a Battery Tender with alligator clips, black to negative terminal, red to post where the red cap had been. That’s it.
What kind of Fuse does a BMW R1200GS use?
The BMW R1200GS LC on-board fuse. One of these will supply power to the relay. Tap the RED/BLUE wire for a switched 12V source. That powers the 7.5A fuse. Carefully splice the RED/BLUE wire. Then tap a signal wire to the spliced wire. This signal wire is used to switch the relay.12V signal wire done!
How does a BMW R1200GS LC relay work?
The BMW R1200GS LC on-board fuse. One of these will supply power to the relay. Tap the RED/BLUE wire for a switched 12V source. That powers the 7.5A fuse. Carefully splice the RED/BLUE wire. Then tap a signal wire to the spliced wire. This signal wire is used to switch the relay. 12V signal wire done! This is how the relay is wired up.
How does the alternator work on a BMW R1200GS?
In many motorcycles, the alternator is simpler than in the R1200GS — there’s usually no belt. The usual set-up is a magnetic rotor that spins inside a fixed stator coil. If the stator coil fails, it stops producing enough voltage/current to charge the battery. The R1200GS’ charging system has one more part — the alternator belt.