How do you change the coolant in a Yamaha Rhino?

How do you change the coolant in a Yamaha Rhino?

Easiest way to change coolant:

  1. Jack up front end so that radiator cap is higher than highest point of motor.
  2. Remove radiator cap.
  3. Remove reservoir tube.
  4. Remove drain bolt from water pump.
  5. Remove bleeder bolt from thermostat housing.
  6. Place end of water hose flush on radiator fill hole. (

Is there a troubleshooting guide for a Yamaha Rhino?

Despite having three different engineering designs since its inception, troubleshooting tips remain mostly consistent across all Rhino models. In order to guide owners through minor repairs and diagnosis of problems, the company offers a troubleshooting guide in all Rhino owner’s manuals.

Is the Yamaha Rhino 700 cc still available?

It was the only side-by-side that Yamaha still offered for 2011 in a 700 cc model. Despite having three different engineering designs since its inception, troubleshooting tips remain mostly consistent across all Rhino models.

When did the Yamaha Rhino UTV come out?

One of two utility vehicle makes that Yamaha debuted in 2004, the Rhino UTV (utility task vehicle) was the longest-lasting. It was the only side-by-side that Yamaha still offered for 2011 in a 700 cc model.

What should the compression level be on a Yamaha Rhino?

The compression level should read about 140 psi. If the compression level is far beneath this reading, take the Rhino to a dealer to have the compression system inspected. If the compression reading is normal, move on to the ignition system check.

Are there any problems with the Yamaha Rhino 660?

Re: Yamaha Rhino 660 problems?? Well, the stock Rhino should see around 42 mph for a top end speed. the speed limiter then kicks in and will remove spark to the plug. two things come to mind. The fuel filter is plugged (crap in the tank from poor QA) and or the gas tank vent line being plugged or pinched.

What kind of air filter does a rhino 660 use?

Air filter was dirty. Took it out and ran it without it for a sec and it only does 40 mph and then starts sputtering and then backfires and dies. I put a NGK DPR6EA-9 in there.

What’s the top end of a Yamaha Rhino?

A guy at our duck club purchased a Rhino in 2006. We drove it one weekend and it was doing about 53. Is that top end for a stock Rhino? The next weekend it would get up to around 35 and just start popping and backfiring. He brought it in today and it wouldnt even start.

What should the top speed of a rhino be?

Well, the stock Rhino should see around 42 mph for a top end speed. the speed limiter then kicks in and will remove spark to the plug. two things come to mind. The fuel filter is plugged (crap in the tank from poor QA) and or the gas tank vent line being plugged or pinched.