How do you adjust the headlights on a 2007 Mazda 3?
You can adjust the headlights on your Mazda 3 by using the 10mm adjustment bolt on the backside of the headlight housing assembly. This bolt will allow the only adjustment available on the Mazda 3. Adjusting your Mazda 3’s headlights is necessary whenever you replace the housing assembly.
How to set the headlights on a Mazda 6?
Set up a screen as shown in the figure below for aiming the headlights. 2. Adjust the tire air pressure to the specification. 3. Position the unloaded vehicle on a flat, level surface. 4. Seat one person in the driver’s seat. 5. Position the vehicle straight ahead and perpendicular to a wall. 6. Set the headlights 3 m {10 ft} from the wall. 7.
Why is my Mazda 3 headlight aiming wrong?
If the headlight aiming is adjusted with cargo in the vehicle, it may not adjust correctly. Adjust the headlight aiming with the vehicle under the following conditions: Tire pressure is at specification.
What should I do if my headlight is not in the correct position?
Verify that the elbow point of the headlight is in the position indicated on the screen. If the elbow point is not in the position indicated on the screen, perform the following adjustment: Insert a Phillips driver into the position shown in the figure and adjust the headlights. 1. Disconnect the negative battery cable.. 2.
How do you adjust the low beam of a headlight?
The reflectors for the low and high beams are an integrated unit. Therefore, perform the headlight aiming adjustment on only the low beam. 1. Point the headlight beams to a wall and verify that the headlight beams are as shown in the figure. 2. Make a screen as shown in the figure using double-weight, white paper. 3.
How do you adjust the headlights on a Mazda 3?
You can adjust the headlights on your Mazda 3 by using the 10mm adjustment bolt on the backside of the headlight housing assembly. This bolt will allow the only adjustment available on the Mazda 3.
What causes a Mazda 6 headlight to misaligned?
Loosen the screws first, then tighten them. If the adjusting screws are tightened first, then loosened, they will continue to loosen when the vehicle is in motion and may cause the headlights to become misaligned. Caution Incorrect servicing of the discharge headlights could result in electrical shock.
When do the headlights turn off in a Mazda?
When the transmitter lock button is pressed and the vehicle receives the transmitter signal, the headlights turn off. When the headlight switch is turned to the position, the headlights turn off. The number of passengers and weight of cargo in the luggage compartment change the angle of the headlights.
Where is the adjustment bolt on a Mazda 3?
Open the hood of the car and locate the adjustment bolt on the back of the headlight housing assembly. Turn the headlight adjustment bolt until the headlight beam shines at the base of the wall or other flat surface near the ground. Ideally, you want the headlights to shine where the headlight beam meets the ground.