How do you adjust the headlights on a 2001 Nissan Altima?
Use adjusting screw to adjust the vertical aim of the lamp.
- Cover the opposite lamp and ensure fog lamps, if equipped, are turned off.
- Adjust beam pattern until cutoff line is positioned at same height off ground as bulb center (on H-Line).
How do you adjust the headlights on a Nissan Altima?
Use the Torx bit screwdriver to loosen or tighten the adjustment screw on the rear of each headlight to pull the light into the proper alignment. Turn the screw clockwise to raise the headlight beam and counterclockwise to lower the beam.
How do you adjust the headlights on a 2017 Nissan Altima?
How do you adjust the headlight on an Altima?
Walk up to the wall with the headlights still on and mark the exact center of each headlight beam, determined by the small circular disc that will appear in the illumination pattern of each light. Note that the Altima has very little if any horizontal light adjustment capabilities.
Where are the adjustment screws on a headlight?
The first thing you need to do is locate the adjustment screws on your vehicle. In many cases, it will be necessary to remove the trim ring from the headlight. Most adjustment screws are located on the top and side of the light housing. They should be clearly marked. If you cannot locate the screws, check your owner’s manual.
How do you remove a headlight from a car?
Use a tape measure to make sure you are the proper distance away from the wall. Turn off the headlights. Remove the trim ring from around the headlights and locate the adjusting screws. These screws are typically found adjacent to the headlight, though some manufacturers put the screws in the engine compartment, behind the the headlights.
When do you adjust the headlight on a car?
The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tapeline on the wall. It can be somewhat difficult to determine the middle of the most intense part of the beam but in general, there should be very little of the overall beam above the line.