How do you adjust the head lights on a Dodge truck?
Place a horizontal and vertical strip of tape in a cross-mark on the wall directly in front of each headlight that is to be adjusted. Place a strip of tape 25 feet in front of the wall on the ground. Reverse your Dodge truck until the front headlights line up directly with that strip of tape on the ground.
What’s the best way to aim your headlights?
Here’s how to aim headlights properly 1. Check your vehicle owner’s manual for the location of the headlight vertical and horizontal adjusting screws. 2. With the vehicle on level ground, park about six feet away from a wall or garage door and turn on the headlights. 3. Next, mark the vertical …
Where is the Torx pin on a Dodge truck headlight?
Turn the torx pin on the top of the headlight to aim the vertical dimension and the torx pin on the inner side of the headlight to aim the lateral dimension. Adjust the pins until each beam hits the wall 2 inches below and inward of the corresponding taped cross-mark. “Haynes Repair Manual: Dodge Full-Size Pickups, 1994-2001”; John Haynes; 2001
Where are the screws to adjust the headlight?
Check your vehicle owner’s manual for the location of the headlight vertical and horizontal adjusting screws. Note there’s a difference between the adjusting screws and the screws or fasteners that hold the headlights in place.
How long does it take to adjust headlights on Dodge Ram?
All-in-all, expect to spend about an hour completing this project. You may need to make further adjustments in the future. Maneuver your Dodge Ram 1500 to within 10 feet of your garage or wall; the ground beneath your truck must be level. Pull the parking brake and disengage the engine, but keep your low beam lights on.
How can I tell if my headlights are aimed correctly?
This should give you a good idea of whether the beams on both sides are aimed correctly. Another method is to pull the vehicle within 5 feet of the wall and then use masking tape to mark the vertical and horizontal centers of the light beams on the wall. Move the vehicle back 25 feet.
How do you adjust the beam of a headlight?
Block one of the headlights and look to see where the other beam hits the wall. It should fall at or below the horizontal tape line you marked and to the right of the vertical tape line. If it doesn’t, use the adjusters located on the headlight housing to adjust the beam until it hits the right spot on the wall.
How do you remove a headlight from a car?
Use a tape measure to make sure you are the proper distance away from the wall. Turn off the headlights. Remove the trim ring from around the headlights and locate the adjusting screws. These screws are typically found adjacent to the headlight, though some manufacturers put the screws in the engine compartment, behind the the headlights.