How do I set up an alarm to work with an speaker?
Switch back to Main View and select your NVR from the side panel. Now, click the small alarm picture and speaker icons at the very bottom toolbar so that they’re both enabled and look like the second image below. This will enable the alarm’s function to send an image of its trigger, as well as the audio.
How do I set my alarm on arming?
Open Arming Schedule, pick an arming template or a custom schedule of hours that you want your alarm active for. Now, Click Settings beside Linkage Method.
How to set up an alarm to work with an alarm clock?
Select the hours that you would like to schedule your alarm to be turned on for. Typically, this would be 24/7, so set the schedule for Monday, Week 1 as 00:00-24:00. Now, copy this schedule to the rest of the week by clicking Copy and then checking the box for All in the popup window.
How to notify surveillance center when alarm is triggered?
Tick the boxes for Notify Surveillance Center and Send Email and then click Apply so that you email notifications whenever the alarm is triggered. If you have connected a separate device to be activated by the alarm in the NVR’s Alarm OUT port, then ticking the box for Trigger Alarm Output will activate this device when your alarm is triggered.
Are there any reports of ipdm failure in the 07?
You’re IPDM might be in the early stage of failing. Like I stated above, some peoples have no luck with the relay swap. Yes there have been reports of IPDM failure in the 07, not as much as the earlier models but has happened. I had starting problems similar to the IPDM issue.
Where can I buy ipdm for my ECU?
-I have read instance where swapping the relays did not help but the problems was solved once a new IPDM was installed. -Unfortunately you can NOT get the $100 IPDM anymore. You can buy just the relay from the dealer.
Why does my alarm keep opening intermittently?
This can become a frustrating problem for alarm owners, alarm technicians, and the police who respond to the false alarms. Intermittent zones are usually due to a failing alarm switch, also known as an alarm contact. Intermittent opens can also be caused by misaligned magnets and contacts.
What should I do if I have a problem with my alarm?
Once you’ve identified the problem zone, start troubleshooting by activating the alarm system’s “Chime” or “Watch Mode” function. This will cause the keypad(s) to sound a chirp or tone whenever a zone is opened.