How do I reset the password on my Cisco wireless controller?

How do I reset the password on my Cisco wireless controller?

Cisco 4400 Series Wireless LAN Controllers – How to Recover the Password on a WLC

1. After the controller boots up, enter Restore-Password at the user prompt.
2. At the Enter User Name prompt, enter a new user name.
3. At the Enter Password prompt, enter a new password.
4. At the Re-enter Password prompt, re-enter the new password.

How do I change my WLC username and password?

How to add / delete /change a user in the WLC via the CLI and apply your permissions.

1. To add a new user with READ or READ/WRITE permissions.
2. CONFIG MGMTUSER
3. You have other options such as delete, description, and password.
4. When you add a user you have 3 permissions:

How do I restart WLC?

WLC: Schedule Reboot Of The WLC From The CLI

1. Did you know you can schedule a reboot of the WLC in the CLI? This comes in handy if you don’t have a WCS.
2. Reset System In -> The (rest system in) command allows you to enter a specific time to have the controller reboot.
3. Rest System At ->
4. Reset System Cancel ->
5. Show Reset ->

What is FlexConnect in Cisco Wireless?

–> Flex Connect is a wireless solution which allows you to configure & control access points in remote/branch offices without configuring controller in each branch office over the wan link. –> FlexConnect is a wireless solution for branch office and remote office deployments.

How do you configure a wireless access point to allow access to a wireless client?

Simply connect the access point to one of the ports of your existing wired/wireless router then configure the access point’s wireless settings.

1. Open the access point’s web-based setup page by entering the default IP Address “192.168.
2. On the web-based setup page, click on Wireless.
3. Enter the Network Name (SSID).

What is Cisco controller?

The Cisco Wireless Controller (WLC) series devices provide a single solution to configure, manage and support corporate wireless networks, regardless of their size and locations.

What’s the password for the Cisco 5520 wireless controller?

Cisco 5520 and 8540 Wireless Controller Troubleshooting Guide Setting up CIMC Note Default password will be either ‘password’ or ‘Cisco1234’. You can change this via the username command CIMC Configurations that are required for reliable WLC operation

Where is the service port on a Cisco 5520?

Service Port. The service port is a 10/100/1000 Base-T management port located on the rear panel. Port 4 in the figure below shows the Service Port on the Cisco 5520 Wireless LAN Controller.

How long does it take to change power supply on Cisco 5520?

Therefore, any change in the status of power supply, fan, or temperature can take up to 600 seconds to be reflected. However, the show imm chassis command can show the current status. Table 2. Cisco 5520 Wireless Controller Front Panel LEDs: Definitions of States

What kind of ports does the 5520 WLC support?

Network ports for 5520 WLC support the following Cisco SFP/SFP+ modules: 1 GLC-T 2 GLC-TE 3 SFP-10G-SR 4 SFP-10G-LR 5 SFP-10G-LRM 6 SFP-H10GB-CU1M 7 SFP-H10GB-CU2M 8 SFP-H10GB-CU2-5M 9 SFP-H10GB-CU3M 10 SFP-H10GB-CU5M