How do I reset my Volvo S60 immobilizer?

How do I reset my Volvo S60 immobilizer?

If the immobilizer is activated, but it shouldn’t, you can reset it by disconnecting power to the Engine Control Module. Look at the fuse box in the engine bay or side of the dashboard. Find the fuse that says Engine Control Module (ECM) and unplug it for at least 5 min. Reconnect it and try to start the engine.

How do I reset my Volvo ECU?

How to Reset a Volvo Computer

1. Open the hood of your Volvo and loosen the retaining nut on the cable clamp running to the negative battery terminal using a socket wrench.
2. Slide the cable clamp off the negative battery terminal.
3. Wait five seconds and reconnect the cable clamp.

What does engine system service required mean on a Volvo?

“Engine system service required” indicates a stored fault code which, as stated above, could be very minor or very expensive or anything in between. The only way to know is to het the codes read with proper Volvo diagnostic gear, generic code readers aren`t usually much help on these.

How do I get diagnostic trouble codes?

1. How to read OBD codes: Preparation.
2. Step 1: Plug the OBD scanner into the OBD port.
3. Step 2: Turn on the ignition.
4. Step 3: Enter the Vehicle Identification Number.
5. Step 4: Find OBD codes in the menu.
6. Step 5: Interpret the first character of the OBD code.
7. Step 6: Interpret the second character of the OBD code.

What causes a Volvo not to start?

The most common causes that hinders normal starting operation of your Volvo S60 are dead key fob battery, dead 12v battery, corrosion on battery terminals, bad alternator, clogged fuel filter, broken starter, blown fuse, empty gas tank, immobilizer error or any fault in the electrical system.

What does immobilizer mean on a Volvo?

The electronic immobiliser is a theft protection system that prevents an unauthorised person from starting the car. The car can only be started with the correct remote control key.

What is Dstc service required?

The system is temporarily reduced due to excessive brake disc temperature. – The function is reactivated automatically when the brakes have cooled. DSTC Service required. The system is disengaged. Stop the car in a safe place, switch off the engine and start it again.

How do you clear the codes on a Volvo S60?

After filtering through the codes, hold the button on the A box down for 10 seconds and release. Then a light should flash. Hold down the button for 10 additional seconds, and all of the codes should clear.

Where to find interior color code on Volvo?

Volvo’s interior color code is found on the VIN plate, or product plate as Volvo terms it. Help finding it is here in Volvo paint codes. Paint codes on vin plate interior and exterior codes. For interior colors, you’re looking for the interior code.

Are there any problems with the Volvo ETM?

1 Symptoms of failing ETM. If experiencing some of these symptoms, your Volvo likely has a bad electronic throttle module, especially if any codes are present. 2 Common Problems. Over time dirt and grime can build up inside the throttle body. 3 Removal and installation procedure. 4 Programming.

What should I do if my Volvo throttle is not working?

Over time dirt and grime can build up inside the throttle body. You can remove the intake air hose connecting the throttle body. Then use Throttle Body Cleaner and a clean cloth to remove the dirt. Remove any loose dirt from the throttle body, or it will end up in the cylinders.