How do I reset my Mazda RX 8?
Mazda RX-8 Maintenance Required Reset
- Press and hold the TRIP BUTTON with the ignition switched off, then switch it on. Keep pressing the selector for more than 5 seconds. Mazda RX-8 Reset Trip Button.
- The master warning light will flash for a few seconds when the reset is completed.
What should I do if my Mazda RX8 wont start?
You can verify you ignition system is ok by checking for spark at the plug while a friend crank the engine. Click here for the engine de-flooding procedure to regain compression and get you back on the road. Basically what you are doing is adding ATF or OIL to the two side ports of the intake manifold (1/2 qt per port).
Can you put ATF in a Mazda RX8?
Yes ATF works good. Yes, do not just start the engine and move car 20 feet and shut off. You need to get the engine warm or hold at 4-5K rpms before shutting off. I put oil in one intake port. could not get the cap off the rear one so I put oil in the lead spark plug holes as the manual said.
Is there a recall on a Mazda RX8?
If you have a problem with your ignition system, (no spark) that would not be covered. The recall is for warranty extension from, 5yrs 50K to 8yrs 100K, if the engine has lack of power, stalling, low compression and may not be related to your concern.
Where are the fuel lines on a Mazda RX8?
There is no fuel lines on the engine. The fuel lines run up the body under the drivers and connect to plastic fuel lines next to the barke master cylinder. The have a red and blue collar on them. Either way, drilling will not harm anything.
Why does my Mazda RX-8 engine not start?
At the time it sounded like the battery, because engine turned very slowly. Since, I’ve changed battery, checked all fuses, and engine still doesn’t start (though it engine turns fine). Would you please assist me with any info which will help me to determine what’s wrong.
What should I do if my Mazda RX-8 stall?
Try puting your car in neutral at the light – the vibration should stop or be barely noticeable. Mazda had a regional rep come out to look at my car, and his solution was to give me my 7th set of motor mounts. The vibration was a little better for about 10 feet, then it was back and worse than ever.
Yes ATF works good. Yes, do not just start the engine and move car 20 feet and shut off. You need to get the engine warm or hold at 4-5K rpms before shutting off. I put oil in one intake port. could not get the cap off the rear one so I put oil in the lead spark plug holes as the manual said.
If you have a problem with your ignition system, (no spark) that would not be covered. The recall is for warranty extension from, 5yrs 50K to 8yrs 100K, if the engine has lack of power, stalling, low compression and may not be related to your concern.