How do I reinstall the emergency brake cable?
On reinstallation, it’s a good idea to feed the cable with the ball end through the stub frame first, get the ball hooked through the spreader, and then feed the other end through the drum. After that you can install the outside retaining clip, then hook the cable up to the lever that gets reinstalled on the shoe.
What to do about stuck parking brake cables?
If I run across rusted/stuck parking brake cables, I cut the cables at the backing plates and then replace the cables while doing the brake job. unfortunately, I have almost zero dollars left after getting all these parts so I m not gonna replace the cable ass.
What to do if your emergency brake stops working?
The emergency (parking) brake pedal stopped working, I made a mistake of removing the emergency (parking) brake pedal assembly. So the first part of this video is good for someone who needs to fix the emergency (parking) brake pedal assembly problems. The second part of the video (rear drum brake) actually fixed my problem.
Can a drum be removed from an emergency brake cable?
the emergency brake cable and the lever assembly without removing the drum. Also, with the outer wheel bearing removed, it allows the wheel much more play on the axle, and by tapping the drum with a hammer, you can usually get the brake shoes to retract a little, even if the cable remains jammed.
What to do if your parking brake cable is stuck?
Release the cable from the rear passenger side brake caliper and try to free up the cable movement with a penetrating rust remover, or if necessary, replace the cable. Maneuver two screwdrivers through the access port on the drum brake backing plate to loosen the tension adjuster screw.
How do you replace the emergency brake cable?
To the lower left, you can see the new emergency brake cable and spring installed. I put it back together in reverse order of the video, starting by hooking the cable up to the lever, then installing the lever on the brake shoe, then installing the brake shoes on the backing plate.
the emergency brake cable and the lever assembly without removing the drum. Also, with the outer wheel bearing removed, it allows the wheel much more play on the axle, and by tapping the drum with a hammer, you can usually get the brake shoes to retract a little, even if the cable remains jammed.
When to replace the brake cable and return spring?
But the time comes when none of these quick-and-dirty tricks work, and the only solution is to remove the drum and replace the brake cable and the return spring, which needs to be strong enough to pull back the brake shoes when the brake is released.